it works great another tip I didnt mention is I have a piece of 2 inch foam insualtion on top of my work table its the funny green stuff in the background works great for sticking tools into like knives and screw drivers keeps them from rolling away

Great job! Thanks for the tips.

I like the idea with the magnet.

Y’all need to make sure you get specially made foam glue.i used normal superglue and it melted the wing off so save yourself the pain and by the good stuff

@sabredriver42

4 жыл бұрын

I guess when I made this video I didn't mention that, depending on what I'm attaching I either use clear gorilla glue if it needs to be strong but shock absorbing like landing gear mounts and such or for a wing joint or other non shock prone area I will use BSI Foam Safe CA

Do you know how fast this plane can go?

Nice' Whats the difference between the v2?

How can access the can I remove the nose cowl to access the motor screws to change the thrust angle?

@sabredriver42

7 жыл бұрын

Niklas Nowak the cowl on my corsair is held in place by a magnet once you remove the prop I just give it a gentle pull and it slides off now I know there are a couple generations of this bird from fms , I'm not sure if they all have the same cowl setup as mine or not. I hope this helps you.

@niklasnowak352

7 жыл бұрын

I have the version 2 and as hard as I can pull I can't get the cowl off

Does it come with a remote

I'm thinking of getting one.. Do I need to get a glue with this?? PLEASE HELP because this is my first time with a RC Airplane..

So did the 50 mm Cog make it fly perfect or did you add more lead later...i have mine at 50mm cog which i will maiden tomorrow... thax

@sabredriver42

5 жыл бұрын

From what I recall, it been a few years it was perfect the first time out.

@roadstar499

5 жыл бұрын

@@sabredriver42 cool. i added a washer up front inside bottom of cowl and have it spot on at 50 mm...thax

I get it without controller