Fitting Yamaha R7 Tail Tidy License Plate Holder
Hi Guys! Just a quick video to show the process of fitting the Yamaha License Plate Holder to my 2022 Yamaha R7. Half way through the video I realised that this holder can be fitted either in Tail Tidy or standard configuration. If you're fitting this as a tail tidy and want the license plate closer to the bike, skip the metal bracket that I introduce at 15:10 and you'll save some time!
#motorcycle #yamahar7 #tailtidy #diymotorcycle
Пікірлер: 11
Thanks a lot man! I was going for a aftermarket plate holder (that I don't like) because I thought that this one was long as the original, and then I saw you removing that part xD Thanks a lot again!
@danshapirotwowheelin
29 күн бұрын
Thank you for your message - I’m really glad it helped!
Thank you for the video! I was afraid to do this by myself, but you explained it very well👍🏻
@danshapirotwowheelin
2 ай бұрын
Thank you! I’m glad you found it helpful! 😄
Good vid
@danshapirotwowheelin
6 ай бұрын
Thank you, I appreciate it.
Hi Dan,great vid. Thanks for sharing. My bike came with manufactures tail tidy with the extension already fitted. Do you reckon I can just remove the ext piece or would I need to remove seat’s and fairings. Thanks
@danshapirotwowheelin
4 ай бұрын
Thank you, I appreciate it! I think you’ll be able to. If it’s the same tail tidy, remove the six screws on the extension piece, keeping just the ones at the end closest to the license plate as seen at 21:15. You’ll need to snap some more of the bendy plastic off so that it’s shorter and slide the excess wires up inside the bike from underneath, but it might save you taking it all apart.
❤
Did the original drill holes of the license plate easily align to the new holder?
@danshapirotwowheelin
Ай бұрын
They didn’t no! I had to drill new holes which were upwards by about 2cm (25/32 USA) and inwards towards the middle by about 1cm (25/64 USA)