Amazing content i don't see why you only get 220 vieuws

@joeygt6794

Жыл бұрын

Thanks for watching, 220 view for me is a lot to be proud of. Hopefully the channel will continue to grow and people enjoy the upcoming content ✌️

Yeahhh bruhhh

@joeygt6794

7 ай бұрын

Thank you man, love your starlet btw ✌️

Should you preload coilovers before installation?👍

@joeygt6794

3 ай бұрын

It’s my understanding that the bc comes pre loaded, but I’ll look into it and will let you know. Thanks for watching ✌️

It's going to be some car when it's finished your dropping serious coin into her love that rear brace never seen one before I'd be interested to see what you think of the powerflex engine mount I personally took mine out as the vibration from it was awful anyway really enjoying your gt build joey 👌

@joeygt6794

Жыл бұрын

Iv never seen on of these braces either, when it came up for sale I couldn’t leave it behind. I’m already dreading the vibrations but what I’m planning is to only run this powerflex mount and then the 2 other mounts will be oem so hopefully that will level it out. Thanks for the support Matthew 🙌🏻

@stephencarr7263

Жыл бұрын

Hi Joey. Stephen (glanza dude) from tgtt. Would you please have the part number for the front anti roll bar ball joints. Did they cost much to buy? Thanks

@joeygt6794

Жыл бұрын

Hi Stephen, I got these from id workz awhile back but I’m sure most auto factors would actually carry them. I’ll leave a link to a set of them for you here - id-workz.co.uk/products/anti-roll-bar-drop-links-front-toyota-starlet-gt-turbo-glanza Hope that helps

@stephencarr7263

Жыл бұрын

@@joeygt6794 that's fantastic Joey and I presume the link you sent me was for the 2 drop links? Thanks again for the videos

@joeygt6794

Жыл бұрын

Ya if ordering just fill in what quantity you need as they don’t come as a set of 2 👍🏻

What wishbones are you using joey ep91 standard ones

@joeygt6794

5 ай бұрын

I’m actually using my standard ones. There was provisions on them to take the anti roll bar even tho the car didn’t come with one originally. Everything from the glanza bolted straight up

@dyl5518

2 ай бұрын

Are these ep80 hubs aswel ?​@@joeygt6794

@dyl5518

2 ай бұрын

Are you using the ep80 steering knuckle where the front coilover bolts to

@joeygt6794

2 ай бұрын

Hey there, so everything is glanza fairly much , the front hubs/disks/calipers all came off a glanza

@dyl5518

2 ай бұрын

@joeygt6794 getting bc coilovers just tryna figure out few measurements. What's the width of the bracket on the coilover for the front knuckle where coilover bolts on and the distance of the 2 bolt holes . Ep80 is 26mm in width and 53mm between 2 holes.