Do the two poperties have to be on the same plane? By the way thanks for your nice and clear videotutorials for Abaqus CAE!

For static analysis it's okey.. What about the same problem in Frequency analysis?

The following error shows when I run the similar model in abaqus using fastener. What could be the reason for this? Error in job Job-1: THE *FASTENER INTERACTION NAME FASTENERS-1 HAS NO VALID SPOT WELD DEFINITIONS. PLEASE CHECK THE FASTENER DEFINITION.

Rojit, I have the same problem, did you figure out the solution to your problem?

I think it's stiffener not fastener.. cmiiw

@sharonbalasubramanian6810

9 жыл бұрын

for stiffer there is another option in abaqus. I found an ASME paper on same for faster. Same condition. For static analysis it's okey. This will work out.But for frequency analysis what boundary condition will give for fastener.. That's my doubt. if you know reply for this :)

@Sunshineshaurya

7 жыл бұрын

Hii! Did you find the answer to your problem? Since i am working on the same thing?