I am surprised that the polarized capacitor didn't fail.

@StablestLeaf

7 ай бұрын

Yep you are right need too use those ciramic one

Hi, I went through some comments and answered some of the most popular questions to the best of my ability! *How does the electrolytic capacitor work with ac current?* It should not, but I'm guessing because he is using very little power in the motor, it did not explode. I would not recommend this though. *What are the specifications of this motor? * Synchronous RPM: 3,000RPM Power: 30W Voltage: 12V AC Current: about 2.5A (but my calculations could be off) AC Frequency: 50Hz *How do I make a rotor for an induction motor? * The rotor used in this video is a squirrel cage rotor from another old motor. This is not possible to make at home, however, you can substitute it in a pinch with a cylinder made of steel. The squirrel cage rotor has copper in diagonal segments which directs the current. *Is there a running and starting coil in this motor? * Yes and No. The coil with the capacitor would be a starting coil, but it is running constantly, which could cause problems with the capacitor. *How many meters of the copper wire? * Each coil appears to have about 36.5m of 26 AWG wire. *Why is it so slow? How to increase the speed of the motor? * This motor only uses 30W so the torque produced is not enough to get it to full speed. The friction of air resistance and in the bearings cancels out the torque at around 100RPM, which you see in the video.

@MegaKopfschmerzen

3 жыл бұрын

Well the channel is called American Tech, and they have 60 Hz AC there, so it's probably 60 Hz

@mantisgaming

3 жыл бұрын

@@MegaKopfschmerzen Yes, the U.S. uses 60hz, but that is a European outlet, so I don't believe American Tech is actually in America. You can see the plug very clearly at 7:47

@djmips

2 жыл бұрын

@@mantisgaming It is likely the UK spec which is also used in India for example.

@bottarohan5030

Жыл бұрын

Hi, what is the capacitor exactly used for in the setup, do we use it in the induction motor for EV's (ofc it might be a different type of it) and if yes how do we connect it if I want to make a induction motor with 6 different coils like this

@ArkhamHedler

8 ай бұрын

I'll explain it in a reduced way, American Tech is a fake channel, it doesn't do real things, even ElectroBoom has already shown that this channel is a lot of lies.

0:54 pls pls pls. Observe safety you're doing it wrong it might take your fingers.

@sechura3698

3 жыл бұрын

Yeah there are like 8 points in this video where I thought he was going overboard starting with that.

I really appreciate project like this, it teaches us a lot buy doing it and not just reading it in text books. Great project

So the induction housing the stator came from serves 2 purposes eliminating the need for that large induction transformer?

ماشاءاللہ بہت عمدہ کام

Superb plzz try to make 230v dynamo in easy way

Nice video sir Thank you so much

Wieviel Umdrehungen hast hier und mit Wie viel Watt fährst du hinein

I can use this for my homemade pressure washer and solar waterpump. Thank you

Finally came to the induction motor

Can you use a polarized cap CV with ac without diodes?

How to make 220v shock proof electricity device.Pls make a video on this topic

all is best👌👌👌👌 but it seems low rpm. please indicate its rpm too🙏🙏🙏

This homemade device, is described as the rotation of an induction motor

Well well,thats nice!

How many volts is that transformer outputting?

Super best example for induction motor 👍👍

where did you get the rotor from?

@twinmama16

3 жыл бұрын

From an induction motor

@jasonmorgan661

2 жыл бұрын

A average fan

Is it possible to adapt your motor in a magnetic motor to do the Tesla Egg experiment ?

Why does the wire in the coil doesn't need to be magnet wire? So that along the wire there's insulation?

Hello, thank you for sharing your project, I have a quick question, what's the input voltage into the project from the 3-phase supply?

@fiddlyphuk6414

4 ай бұрын

3 phase supply? LMAO

Where did you get the squirrel cage rotor? Is there any alternative to it?

@mantisgaming

4 жыл бұрын

A solid piece of steel should work fine for diy

me gustó! 👌

@channel-cz9tk

4 жыл бұрын

Это якорь

What does he put on the Wood Circle? The silver round center part of it? Serious question.

@cia3653

8 ай бұрын

a wheel bearing

hi there, what capacity used for?

Bagus untuk pembelajaran di kampung kami

lam from iraq and l love this channel 🇮🇶

I found that author has misguided the viewers because in the "Motor Circuit" drawn in video as only one wire connected to each terminal of Electrolytic Capacitor 2200 Mfd. /35v. where as in the practical, each terminal has soldered pair of copper wires....?

how many meters of the cooper wire?

Excellent. Keep it up.thank you dr. Faradey

How electrolytic capacitor can fit ac current.

@psun256

4 жыл бұрын

big big boom time

@Siiiloke

4 жыл бұрын

It work, sirve para desfasar la corriente del voltaje

@lifelonglearningchannel5610

3 жыл бұрын

Ya electrolyte cannot fit

Make a motor that good in offroad skateboard like alien power motor and make it's design

How does an ordinary iron cover rotate without a magnet?🤔

Single phase or three phase??

May be capacitor blast due to reverse polarity..? You put fixed polarity capacitor in direct Ac current If using 5amp transformer

Was that insulated copper wire or normal copper wire

@HVACSUPERTECH

5 ай бұрын

definitely, magnet wire

Energieverbrauch ?

Muy bueno el video, felicitaciones, saludos desde Jamundí Valle del cauca Colombia

*IF THAT WERE REAL, YOU WERE RICH*

Ac motore diy hand made good idea

How many motors you have

if you use 3 coils in 3 phase ac it will run much better

Why so high of a value an not 3 or 4 or 5 uf?

Now that's really interesting man. Thanks for sharing. Is there a running and starting coil in this motor?

@psun256

4 жыл бұрын

No, the capacitor is always run, making it quite dangerous.

@mantisgaming

4 жыл бұрын

There is a starting coil set, but they're always running so that capacitor is likely being overloaded, at least if he were running it at maximum potential

@sidamarali3030

4 жыл бұрын

@@mantisgaming Thank you

@sidamarali3030

4 жыл бұрын

@@psun256 Thank you

Can someone explain why the need for transformer?

Nive vedio and very useful thanks

Very good 👍

why dosn't the screw bag rotate ?

You are too good bro

Doesn't the copper wire short circuit because it touches each other?

i'm not sure if it considered a DIY since the rotor is not hand made too

А почему он вращается? В центре ротор необычный какой то.

@channel-cz9tk

4 жыл бұрын

Он маломощный такие стоят в основном в вентелятьрах

@CrazyBlackHacks

4 жыл бұрын

Марат Власов я в руках такого недержал может будет какой то вентилятор разберу гляну

What is the size of the volts?

this good video.

Polarized capacitors are not used in AC currents.You need to convert the current to DC.

@Shorosky

Жыл бұрын

The way he made the rotor let him to use any kind of capacitors.

Can you use a dc capacitor in ac??? I am confused

@Matthew11_

Жыл бұрын

The answer is simple. NO

Is that a microwave transformer you plugged in at the end?

How can i control its speed

@omaribrahim5008

4 жыл бұрын

I think more frequency

A induction motor works on AC current, so why you used polarized cap?

@a3axon

3 жыл бұрын

The cap and transformer form an oscillator that can drive the motor at differing speeds depending on the frequency of the oscillations

@adrianodemetrio5607

3 жыл бұрын

CHRlS no, the frequency of the system is dictated by the supply, so always 50Hz

@adrianodemetrio5607

3 жыл бұрын

It is wrong indeed, the cap must not be polarized

where did you get the rotor man ahhahaa

Ye penonton pertama

What is the imput voltage please?

@Imtiyaz5power

4 жыл бұрын

220 v ac.. output 12 v ac

Should I use copper wire coated with an insulator for it? Please dm me

@JjMn1000

3 жыл бұрын

yes

@monishankardas2802

3 жыл бұрын

@@JjMn1000 thnx☺️☺️

Ok felicitari

Make a prototype

Электролит в переменку- это пиздец гениально.

thanks! from what material and components rotor made of?

@mantisgaming

4 жыл бұрын

It's steel (pure iron) and either diagonal conductors or insulators (I forget which) to direct induced current in circles.

@apristen

4 жыл бұрын

@@mantisgaming interesting is it possible to make permanent magnets from standard M8 or M12 nuts&bolts? or maybe another easily to found material? it takes a long time to wait neodym magnets (45-50 days) where I live...

You can make a motor without a magnet?

@Blackvertigo1

3 жыл бұрын

@Aryan D duuude! I thought all motors required a natural magnet of sorts. Cool.

Your schematic is completely different to what you have assembled!!!!!!!!

Name of music plzz brother!

more like Indian Tech

Whaat...your transformer is ac..no bridge rectifier??? Ac to dc ?

@JjMn1000

3 жыл бұрын

it creates a phase offset that also offsets the magnetic feild so it rotates

2:50 sec how to make

@mantisgaming

4 жыл бұрын

Yeah, like he just expects us to have induction motor cores laying around... They're made of iron and diagonal insulators (or conductors not sure) but a cylindrical piece of steel should work fine for diy

Очень забавно, но электролитический конденсатор нельзя включать в цепь с переменным током! Funnily enough, an electrolytic capacitor cannot be plugged into an alternating current circuit!

Not a very good motor for anything but cool to see

Person making the spamming comments saying “...” please stop, spamming makes a mess in the comments. And for anyone who thinks this induction motor is fake, go research how it works. This is technically a real induction motor, even though it might have weak torque. Not all motors have good torque.

Super skill

Ossum

Interesting design and creation. After watching the recently released movie Tesla, I envisioned a self sustaining electric conducting motor. No need for batteries or an outside current to power it. Just give it a spin to conduct a continuous flow of energy to keep the rotor in motion.

What is that wheel like thing 2:56 😅

Can some1 explain why to use a capacitor there ? Is it for shifting one phase for 90° to have a two phase system ?

@prockernice900

2 жыл бұрын

Yes

@fiddlyphuk6414

Жыл бұрын

It allows it to be self starting

Thank you!!!

, why electrolithic cap???

@coastersaga

7 ай бұрын

Phase shift.

Power it with a solar cell or wind turbine and and make all the climate nutters cheer.

It should be running at a speed of 1800 rpm as per 120f/p formula why is it running slow is it due to capacitor or transformer

@mantisgaming

4 жыл бұрын

Actually, since two of the magnets are on an offset phase from the capacitor and he has 50Hz electricity, it should be running at 1500RPM. The problem is that he's only powering it with about 10W so most of its torque is canceled out by friction once it reaches about 100RPM, which you saw in the video.

@nishitjoshi1600

4 жыл бұрын

@@mantisgaming thank you for the information

@alessio55555

2 жыл бұрын

@@mantisgaming hello, what is the correct capacitor and the correct voltage to get torque in this circuit? Thanks in advance

@mantisgaming

2 жыл бұрын

@@alessio55555 I'm not an expert, but from my knowledge, to increase the torque, you need to increase the voltage and capacitance. Check the resistance of the coils though because if the resistance is too low, a lot of current might go through them which could melt them. To increase the resistance of the coils, you can use thinner wire and add more wraps.

Wow good

If you see the results of your work, from the aspect of innovation I am amazed and salute you. But if in terms of electrical engineering, the circuit is not correct. Why? The DC electrolyte Capasitor 2200 uF mount is of no use, because you did not install a diode from the transformer secondary to the circuit that aims as a voltage rectifier.

@wander9499

Жыл бұрын

where do I learn all of this without going to school?

Motor for fan

Thanks

Где взять такой ротор?

@user-eg2ng8gk9f

3 жыл бұрын

С любого дохлого вентилятора на 220В

transformer does not work on dc voltage

Super and cool

wow 3 ads

What is the material at 03:08

@THETERMINATOR998

3 жыл бұрын

Epoxy glue

part 2, u make generator 12v 500w use magnet

1st

Where you got that Squirrel cage rotor?

@sidamarali3030

4 жыл бұрын

In a fan , a wall fan .

Please follow this channel, may build flying saucer without any instruments....

Hi