Epson Head Cleaning, l110, l3110/L110, L210, L300, L350 & L355
Ғылым және технология
#epson #headcleaning #solution
How to clean clogged or blocked printer head nozzles manually
epson head cleaning
head cleaning epson
how to fix Epson head cleaning
How to Flush and Clean a Clogging Printhead Demonstrated
Clog cleaning Syringe Attachment for Epson Print Heads
Cleaning the Print Head - Epson
In this video I will show you how to clean the head manually
if the power ink flushing doesn't work you need to clean it manually
it all because I have kept my printer idle for more than 1 month due to covid pandemic
For this method, you need a syringe, a small tube which u will get in any cycle shop
and a glass of clean water. Continue injecting the solution for all the other holes until only clear liquid comes out.
When using this method, position the printhead up so you don’t get liquid to the electrical components. When you are done make sure to wrap the printhead in cling wrap or foil to prevent a mess when leftover liquid comes out. Make sure the connection side is still facing up
Thank you guys for watching please do subscribe plz like the video if you have the same problem do comment four more such problems
#vnproduction......
EPSON L110, L210, L300, L350 & L355 HEAD CLEANING & RED LIGHT BLINKING SOLUTION.
Пікірлер: 19
Thank you for the video
A nice demonstration of why we should wear disposable gloves before doing such cleaning. Nice tutorial though. I got what I need.
@rithikashah1665
3 жыл бұрын
Just use oil and soap and everything will come off in seconds
How do you clean up that ink (hands...)?
Is it ok to use distilled water instead of cleaning solution?
Kya Epson l355 ka head l210 ya l220 me use kar sakte he
7:40 _If by any chance the water goes, you need to keep it for 24 hours._ Not sure what he means by that. Maybe if the ribbon cable terminal of the print head gets into contact with the water, you need to wait 24 hours to make sure it is dry again?
@Pixelsplasher
Жыл бұрын
UPDATE: Now I know why we must wait for 24 hours. I just learned that the print head fuse labeled F1 on the motherboard can be blown if the print head board comes into contact with water. The printer may operate normally but the dead print head will not print anything! The tutorial did not stress this important information.
hi po saan po nkakabili ng cycle tube?
@rendHELL06
11 ай бұрын
lazada
did not show after cleaning if it worked on not, dislike for that!
My printer head totally blocked after this
@Pixelsplasher
Жыл бұрын
Your print head fuse is probably blown due to short-circuit with water.
@raulsipos315
9 ай бұрын
@@Pixelsplasher yes but can be fixed. Do you know where exactly is located because my axis moving but without colors and I cleaned with isopropanol.
@Pixelsplasher
9 ай бұрын
The fuse is labeled F1 on the motherboard,@@raulsipos315 . It is located near the ribbon cable going to the printhead.
@meandutarot
9 ай бұрын
Greetings, once tried to clean it on my own, but the info I referred didn't put stress on the head to get damage, and that happened. I had to take the printer to the service centre. It could cost around 3500 to 4000 depending on availability and sellers pricing.
@meandutarot
9 ай бұрын
Hello, just completed cleaning, while doing so put on cello tape on the side where the cable is connected. After cleaning, I put the cartridge under the fan for some time and yup, it is ready to print.
Dumb video.... What is the point if you not showing printing a test page.