MASSO Rocks!!!

Cool ! 👍

nice would like to see a emco vmc100 !

nice , the biggest issue with those emco turns has always been the control cabinet. I'd be worried about your keyboard though... if you can use a standard keyboard you might want to replace it with a flexible sealed keyboard from amazon (about $24 usually) shop environments are brutal for PC keyboards

Just got my G3.

How old are these emco 120 lathes 1980s 1990s ? And how much would a used one be worth?

Is this CE certified and if not are there any plans to get it CE certified?

bonjour quel mandrin avez vous installé svp ? merci

hi, i did a retrofit from an EMCO Turn 120 too with the masso touch. everything works but i am confused about the homing settings in combination with the axis settings. would you be so kind to share the homing and axis settings (for the x-axis) with me

@MassoCNCAustralia

3 жыл бұрын

can you please email us on support and forward your questions there, we should be able to give you some info via support or MASSO forums www.masso.com.au/forums/

@msanguyu

2 ай бұрын

Hello, how did you do the conversion?

Where can we find more information on this retrofit?

@MassoCNCAustralia

3 жыл бұрын

you can try our forums www.masso.com.au/forums/

@annaarze603

3 жыл бұрын

@@MassoCNCAustralia I will take a look, thank you for your reply.

Original Tool change motor?

@diferencial1234

4 жыл бұрын

yes

@vincentamiel7758

4 жыл бұрын

žan kožman can you share wiring diagram please?

@diferencial1234

3 жыл бұрын

@@vincentamiel7758 I made simple circuit with 3 relays, because masso is only giving forward and then back signal. Relay circuit apply voltage when no signal from masso is given so the turret stays in place and tools can be mounted in eather orientation.

@ngaudio315

3 жыл бұрын

@@diferencial1234 very nice job! I have also have an emco turn 120 that I also like to control with masso. Can you explain the tool changer setup in masso in more detail? Did you used the original sensors?

@diferencial1234

3 жыл бұрын

@@ngaudio315 sorry, didnt see your message. logic for tool changer is in the masso. but you need to make cuircuit with relays so that voltage is aplied to the motor in opposite direction, when tool is not changing. so your turret doesnt move during turning. sensors need to be changed becauseoriginal sensors are npn or pnp, i forgot but you need other ones that are instaled.

Steppers?

@diferencial1234

4 жыл бұрын

Yes, closed loop steppers. With position error feedback to the controller.

@annaarze603

3 жыл бұрын

@@diferencial1234 where can we find more information on this retrofit?

@diferencial1234

3 жыл бұрын

@@annaarze603 what do you need to know?

@annaarze603

3 жыл бұрын

@@diferencial1234 just wanted to know if this retrofit uses the original motor for the turret and how it was connected. Thank you for your help in advance!

@diferencial1234

3 жыл бұрын

@@annaarze603 yes, motor is original. masso has implemented control for this turret. but you need to connect it through relays. when no signal from masso is given, you need to apply voltage to the motor so turret does not move when turning. 24v 1a is okay, motor does not heat up as some people said it would and holds turet in place strong.