I just found your video AFTER buying and setting up my Elegoo Neptune 4 Max. I had a Creality Ender 3 V2 that died. I have experienced the issue where when you select a new print, the preview doesn't come up. Rebooting the printer fixed this issue for me. I have beej printing literally non-stop since I got it this past Monday and so far so good.

Must let it heat up for about 20-30 minutes before leveling because the bed warps up and down while it heats up. After time it will stop moving and you can get an accurate leveling.

@3DPrintsBuilds

2 ай бұрын

Yes, that helps.

Do you plan on making a video using the dual extruder and a full bed print with this printer?

@3DPrintsBuilds

3 ай бұрын

This printer has dual-gear direct extruder. I don't think it has option to add second extruder or what do you mean about dual extruder. I have done big prints. You can see it in my other videos.

@desktop3d

3 ай бұрын

@@3DPrintsBuilds I was asking about a big print on this printer, specifically. At 4:20 you said the nozzle was too close on the edges and at 4:38, after updating the firmware, you said the printer was not level for printing big models.

@3DPrintsBuilds

3 ай бұрын

@@desktop3d The problem was also before the update. The update didn't change anything. To get better results printing big prints you need to preheat the bed about 20-30min then auto level before every print.

@desktop3d

3 ай бұрын

@@3DPrintsBuilds I would need to see a full bed print with two colors on this printer before considering to buy it. Thanks for the video!

How has the printer performed so far after this video, any major issues?

@3DPrintsBuilds

3 ай бұрын

It works fine, no new problems have appeared.