Cant thank you enough for making this video! Its so hard to find info on these mini ex's!

@86ServiceTube

5 ай бұрын

No problem. Thanks for watching. Will do some more stuff when time allows.

very helpful, and easy to understand

@86ServiceTube

5 ай бұрын

Did the best I could with the time I had. Thank you for watching!

thanks for making this. Very helpful. Would like to see video for fan install.

@wmeastman

3 күн бұрын

I also would like info on sourcing the fans. Thanks

Thanks for the video.!!!!

@86ServiceTube

5 ай бұрын

No problem!

How about a picture of the wiring diagram for the ignition system

@86ServiceTube

Ай бұрын

I am not sure that one exists.

What size of battery is in it? CCA?

Very helpful video. Do you know the maximum wattage these stators produce? I thought it was 10 amp which would be 120 watts from my very poor (not confident) estimates but if you're running 2 - 80 watt fans with no issue it must be higher then that. Thanks.

@86ServiceTube

5 ай бұрын

I do not off of the top of my head. Pretty sure the stator on this engine is 20 amp 10 per leg but do not quote me on that I would have to look at the specs.

I recently experienced an ignition switch failure.....not waterproof.... i attempted to wire in a generic switch but with no luck. I found a stock replacement online but failed to take a picture of the harness plug wire orientation. Could you possibly show a picture of how the wires insert in the harness plug? Mine has 2 yellows together, 2 yellows w/ white stripe together, a white, a green w/stripe, and a black. Just a picture as its plugged in would work....Thanks in advance and thanks for the helpful videos...

@86ServiceTube

Ай бұрын

Sorry I just saw this did you get it figured out?

I have a brand new mini excavator and the ignition switch locked up to where I could not turn the key so they sent me a brand new ignition switch which I put in but now it turns over but it will not start so they sent me another ignition switch which was just a nap a universal switch with a hand Ron terrible wiring diagram. It’s still turns over but there is absolutely no spark else works. I wondered if you had any insight on this.

@NorthernWilderness-iy9lx

2 ай бұрын

I have the exact same issue, replaced switch but it’s like engine has no spark. If you figure out a remedy it be great to know.

@86ServiceTube

Ай бұрын

I am sorry I have been away for a while. But I would check the black wire that goes to your ignition coil that is what shuts the engine off by killing spark.

Do these mini’s go into free wheel down hill ?

@86ServiceTube

5 ай бұрын

I have not experienced it. But I have heard of it. I haven’t had it on any major hills yet.

So what turns the engine off electrically? The key switch or the big electrical disconnect? And why. Thanks for your time Chad.

@86ServiceTube

5 ай бұрын

Sorry I did not go over that! Thanks for calling me out. The keyswitch controls the engine kill. I will make a video on that when the weather gets above 0 degrees 😂

@oozzwa

3 ай бұрын

I would also like more detail on the key switch. Mine has issues and I’d like to replace it but can’t figure out which wire is which.

@wmeastman

3 күн бұрын

My ignition switch failed, so I got a Kubota switch. I IDed three of the terminals with an ohmmeter and got it to crank, start, and run. But, the engine does not stop when switched to the off position. I ended up pulling the spark plug lead. How it it designed to stop running?