The best video on KZread showing you how to tye and connect you connectors Thank you i really appreciate it

Many thanks Graham. I now understand how to attach my rigs to a dacron connector & quick release them also how to tie a Crows Foot!

Nice one mate Dacron was doing my head in, I prefer the old “stomflow” method but I’ll see what all the Dacron rave is about

I’ve watched many pole connector videos this is by far the best. Not only how to attach the connector but also putting the rig on. Might seem easy to seasoned anglers but new ones like myself who haven’t attached the Dacron and double loop it’s very helpful. Thanks

@grahamwestfishing7945

3 жыл бұрын

Thanks for your feedback buddy 👍 much appreciated 👍

Great video man. Nice job, well done ! thank you very much !

Nicely produced 👍

Very helpful, great little vid. 👍

Really well explained, just the job

Great explained video Graham

@grahamwestfishing7945

3 жыл бұрын

Thanks for your feedback 👍

Great explanation subbed.

A great tip for the double loop, I have always made a loop then tied a smaller loop which can be fiddly with sausage fingers 👍👍👍

Thanks. Very helpful.

Great video but why do you put your Dacron bead on the other way round to most people? Normally the larger diameter part sits against the pole bush and the smaller end towards you rig.

@grahamwestfishing7945

2 жыл бұрын

Hi Richard , glad you like the video .. I’ve personally found that by reversing the bead , it pro longs the life of my elastics 👍

This is by far the best & clearest no-nonsense video I have seen explaining these alternatives - well done! One thing that could have improved it is to explain/show that it's really easy to make your own dacron connectors. The only thing I didn't understand is what was special about the small loop (of the double loop) that needed a loop tier?

@CB-xr1eg

Жыл бұрын

Bit late replying as I only just saw this video, the small loop is only there to detach the rig from the Dacron connector/crows foot after fishing. Just a small tug will remove the rig from the connector. If you don't do the small loop you have to use a knot picker to open up the big loop in order to remove the rig.

You need to wet knots in line and elastic before tightening, if not then they can cut into each other and weaken, causing breakages. Otherwise a very informative video. Thanks.

Orange cap looks far better the other way around.