Must save video for anyone with a tormek, great info.

@SharpeningSupplies

Жыл бұрын

Thanks! Glad I did this video, I'm greasing my bearings now!

Make sure you clean off all the lubricant on the stone side where the driveshaft comes through. I left it messy when I did mine, and over time the white grease spread all over the inside and outside of the SG-250. Luckily not the actual grinding surface.

@SharpeningSupplies

6 ай бұрын

Good tip!

Tip 7 - you might get the bump on the leather wheel if you have a build-up of honing compound in one (or more) spot/s.

@SharpeningSupplies

Жыл бұрын

Good tip.

A turkey baster is an inexpensive, handy way to drain the water from your water trough. No spillage. When you are down to the sludge, use a paper towel. Give a final rinse with clean water keep your water trough like new.

@SharpeningSupplies

Жыл бұрын

Fantastic tip!

Great Video!! Thanks.

I have a tormek t4 bush craft. I've noticed a loud noise. Any advice on how to fix that? It only happened when i would apply pressure with my knife, but now it makes that noise all the time. I tried cleaning and re-greasing, but that didn't work. Any advice would be helpful. Thanks.

what was the truing stone for

@SharpeningSupplies

11 ай бұрын

The truing tool levels the surface of the grindstone.

@lassevejbymadsen9288

9 ай бұрын

No it’s for changing grit on the sg-250 stone

@SharpeningSupplies

9 ай бұрын

@@lassevejbymadsen9288 Good point, there are two different things, the Truing Tool levels the grindstone surface, while the Stone Grader can refresh the grindstone surface and make the effective grit coarser or finer.

@johnhall8455

5 ай бұрын

It’s not a Trueing Stone…it’s a stone grader…for changing the grit grade on the wheel