Easy Way To Remove Stuck Cv Axle Without Damaging Threads
Автокөліктер мен көлік құралдары
This is the way that works best for me. Some axle nuts to have a washer built on the and you could use the socket and nut combo to knock it out. Keep in mind with that way you could break the washer off.
Пікірлер: 28
GENIUS!!! I think I lost about 7 brain cells watching this
@repair_tech_brian5388
8 ай бұрын
Who needs them anyway 🤣
@Mclovinxxx23
8 ай бұрын
@@repair_tech_brian5388 obviously not anyone that watched this video
I have used a 2 pound brass hammer with a mini sledge, place the brass hammer on the end of the cv shaft then pop it with the mini sledge and out it comes easy peesy. I have been removing cv shafts since they first came out and have done this all these years to easily remove them.
@repair_tech_brian5388
13 күн бұрын
Every one has their preferred method. One way that works best for them.
how about just put the axle nut on the edge before hitting it?
Rotary hammer works best. Around $60 at HF
Made my day. Thanks
@repair_tech_brian5388
6 ай бұрын
Welcome
Thank you
@repair_tech_brian5388
Ай бұрын
You're welcome
So I’m guessing this is stronger than an air hammer with the chisel adapter huh
@repair_tech_brian5388
7 ай бұрын
This is for those who don't have access to the air Hammer and compressor.
A dead blow, or brass drift can do it without damage. In my limited experience.
@repair_tech_brian5388
6 ай бұрын
I have not used either.
It's so stuck I broke the punch. I tried bigger punchers but it's still stuck. Now what?
@repair_tech_brian5388
12 күн бұрын
Sledge hammer
@Schapezak
11 күн бұрын
@@repair_tech_brian5388 I found a video of someone using a deep hub puller. Worked like a charm. Was $32,- at AutoZone. Took me 2 minutes in total to put it on and push the axle out
Or you can take the axle nut, put it on the threads and hit the axle nut
@corymerry3399
2 ай бұрын
I did that and my threads still got messed up. The punch worked great for a frozen cv
Ok but what to do when hitting with a punch doesn't work?
@repair_tech_brian5388
10 ай бұрын
Heat it up.
@hemtet5500
9 ай бұрын
Ha ha what happens when you’ve got a twenty ton puller oxyacetylene and a seven pound sledge all working hard on it and it still doesn’t budge?
@repair_tech_brian5388
9 ай бұрын
@@hemtet5500 probably replace the spindle assembly and cv . 🤣
@hemtet5500
9 ай бұрын
@@repair_tech_brian5388 that is what I'm thinking damn
@95poo40sx
7 ай бұрын
I find heat and an air hammer/big hammer drill on hammer mode works the best. Just had to fight one the other day with heat and a big air hammer. Just kept going up in sizes with the air hammer after the sledge didn't work