Easy Halloween coffin from one sheet of plywood.
Тәжірибелік нұсқаулар және стиль
This coffin is 6ft long, 2ft wide, and looks authentic, especially if it's stained or painted. It took me about 2 hours to build. I could have finished it sooner if I had not stopped numerous time to move the camera, so it could probably be done faster. You only need a saw and drill with a screw bit.
Parts: top and foot - 11.5 inches square
top angles sides: 17.5 in x 11.5 in
long side pieces: 11.5 in x 56.5 in
5 pieces of 36 in 1x1s (these are 1 in square)
about 50 1 inch screws
Thanks for watching. Happy Halloween.
Пікірлер: 15
Thank you for your easy-for-even-me-to-follow no waste tutorial! We made 2 today :)
@MikeM100
3 ай бұрын
Awesome. I'm glad it could help you. Thanks for watching
FOLLOWED THE VIDEO AND MADE ONE LOOKS GREAT PAINTED IT TOMBSTONE GRAY AND BLACK ON THE BACK PANEL PUT THE SKELETON IN IT WITH THE MOVING DIGITAL BLINKING EYES AND A BLACK LIGHT ON THE INSIDE BOTTOM LOOKS GREAT THANKS MIKE !!
I'm impressed. Well done. Thanks for sharing.
@MikeM100
Жыл бұрын
Thanks. I appreciate you watching.
Thank you for sharing this!!! This is what I’m wanting to do for my display!!
@MikeM100
Жыл бұрын
Thanks for watching.
Get a chalk line. Otherwise, good job.
@MikeM100
Жыл бұрын
Thanks. I'm definitely not a carpenter.
How do you get 56" out 4 feet of borde ??
@MikeM100
11 ай бұрын
Cit lengthwise. I showed it in the video
@kevincollette2985
11 ай бұрын
I did exactly what you said on your video length ways top and bottom yes but the top of your board that's remaining is 4 feet by 2ft 8 which is 48in Buy 32in how do you get 56 in for the sides of the coffin out of 48 in
Can this be done using 5mm plywood?
@MikeM100
10 ай бұрын
Yes, but it would not be very strong structurally.
@GG-ry9vp
10 ай бұрын
@@MikeM100 would I have to glue the sides or some how screw or staple it if I were to use 5mm plywood? Or what would you recommend if I were to use 5mm plywood