Great info. Thanks man. Will be watching.

@dnjmachine

Жыл бұрын

Thanks for watching!

good shit!

@dnjmachine

Жыл бұрын

Thanks!

Similar to how I do it (machine flats), but instead I type in mdi a g43 line reading my tool height abs go to z1.0. (I wont rapid to 1.0 and I'll be far from the 5th). I then hand crank flats on material. Measure part. If 2.002, I'll drop g57 z-.001. This method is a 2 wrongs make a right method because you're at the mercy of the tool setter. I'm trying to figure out a better way after I've machined a square up at B0.

@dnjmachine

7 ай бұрын

I noticed the same small error some time after making this video. To dial it in I cut some stock into a square with 4 facing passes in CAM software. Then do a contour or profile pass of the same square from above. Then adjust my offsets until they facing and profile passes match seamlessly. Then its perfectly aligned! Hope that made sense.