Early Test of the Smart pro Air do X
I will do a "fancier" video when I film some jewelry etc... but I just had to give it a try! early
pepetools.com/products/pneuma...
In depth instruction for folks wanting to learn engraving on my patreon channel!
patreon.com/Texasengravingschool
Пікірлер: 20
great review! i recently got one. . im not an engraver. . but a setter. . I am truly enjoying this little machine. . I got a 2nd handpiece from the katway version. . It works just as well. . It's a different QC system. 2.3mm
@ians9390
Жыл бұрын
damn, so my grs QC wont fit?
@mruscfreddles80
Жыл бұрын
@@ians9390 the grs qc is 6.3mm. . the airdo is 6 .1mm
@ians9390
Жыл бұрын
@@mruscfreddles80 Just ordered mine. Cant wait. So the brightcut is nice without those stutter lines?
Can you use other gravers such as GRS Quick Change gravers or Vallorbe with your collets?
Thanks a lot for your review! Convinced by that, I bought an Air Do X and I'm happy with it but, being an absolute lay(wo)man, still trying to get into it. At which speed did you run the handpiece 1.) at using it as a hammering handpiece, 2.) at using the beading tool and most of all 3.) at engraving? I'm too unexperienced and do not know which forces I'm allowed to put on the machine and how much I can expect from it, without ruining anything. Thanks in advance for an answer!
thank you this is very helpful for beginners like me, I hope later there will be a video about sculpting, for example on coins, a little practice on how to do it
Thanks for the review!
hi, i’ve just bought an air do x from pepetools.. yesterday i tried it but it doesn’t engrave like in your video.. it doesn’t engrave even soft metals like copper/silver😅 it has a beautyfull design, its made well but there’s something strange because it dosn’t the only thing that has to do (engraving)😭
Every time I look at it, it reminds me of a bread toaster
This tool can be use it for Stone setting to ?? Thanks for sharing this review!! 🙏😎👍🇨🇴
I was looking on that machine thanks
Great job...!!!
Is the power adjustable or is it only the stroke speed?
this is interesting. i see you cut the scroll and remove the background with the same tool how many degrees did you use?
will it accept grs quick change or conventional gravers?
@mruscfreddles80
Жыл бұрын
no. . its smaller diameter
Jeleous of your talent
I have tried this machine and it´s not good at all. Such a respected engraver like you saying this is good, is a joke. It´s obvious you are in their pockets. You can even see it on your engraving with it, it leaves a lot of cutting marks, and you can not possible like it!
@GuiGuiYYDS
8 ай бұрын
Hello, I’m looking to get an engraver, is there any suggestions?