Find troubleshooting support, mentorship, and education at chilleracademy.com. Once enrolled you will have access to The Chiller Community! Invest in your future and get help growing today!

You should go on the HVAC Overtime show and spread the word about your chiller academy

Hey really enjoyed the video & information I would like to see videos on steam turbines & their surface condenser / Hot well if possible ?

You should open a training institute in the USA. Internationals come there and learn more with practical teardown,overhauling etc and get a certificate from your institute. ❤

thanks a lot man, keep'em coming

@HVACTIME

Ай бұрын

If you would like to join the chiller community for support and mentorship, I have one at chilleracademy.com. Everyone who is enrolled in any course will get access to the community and benefits.

@kiloizoldyk7064

Ай бұрын

@@HVACTIME I 'd be honored , at the moment i'am just a rookie working for trane ditributor in Algeria , i love this profession , and i hope to learn more and more

I’m a bit confused by your explanation. We have an air cooled Carrier 30AX which have the condenser water coming in the end bell & feeding from the TXV to the bottom and suction line on top, but the literature calls it either flooded or DX and I had a hard time determining which was which. I think it is flooded based on your definition BUT the manual says it should maintain EEV position based on discharge superheat. But I find it is maintaining the EEV position based on Suction superheat, which is called out to be for the DX setup. What are your thoughts? I suppose it could be configured wrong but the units are 15 years old!

What would cause intermittent low refrigerant temp alarms on a CGAM chiller?

@HVACTIME

Ай бұрын

Several things, refrigerant charge, water flow issues, transducer or thermistor issues, or eev issues would be first things to verify. All of those can have intermittent symptoms. I have a chiller community for everyone enrolled at chilleracademy.com where you can get indepth troubleshooting support!

What method do you use to verify proper flow on a DX Evap?

@HVACTIME

Ай бұрын

@l.crossjr I use water DP and compare to design specs.

You did not menshion full falling film evaporator

Approach will increase with glycol

@HVACTIME

Ай бұрын

True