Durco Mark 3 ASME Chemical Process Pump Maintenance
Ғылым және технология
This video takes the viewer step-by-step through disassembly, inspection, and reassembly of the Flowserve Durco Mark 3 ASME chemical process pump. Sections include:
• Disassembly
• Power End Assembly
• Power End Inspection
• Wet End Assembly
• Impeller Clearance Setting
• Mechanical Seal Installation
Пікірлер: 19
Would love to see rebuild videos for clean water vertical turbine production pumps. The vast majority of the different seals I work on are Flowserve. Pumps typically have an rpm around 1800 with flows of 6k-8k gpm. Shaft sizes range from 1 inch to 2.68 inches on average
dual mechanical seal you can lock set screw after you setting clearance impeller
j'aime bien les informations concernant les travaux oil and gas
Thanks my dear From Pakistan
Dear sir i have an doubt about vertical multistage pumps. My question is Why the vertical multistage pump dont have balancing drum arrangement to cover axial float of rotor...?
با سلام مطالب علی بودند ممنونم
Wow superb
Super knowledge 👌 👏
Very nice bro...
EXCELENTE
Hello, Can you put Vertical turbine pump maintenance video. Model: 12EHM-4
@Amjadkhan-uu7uz
5 жыл бұрын
R u mill wright technician???
11:51 shaft end play 0 right??
Next bedeo sir ji
These pumps are trash. I don't see how they can try to call them an ANSI pump. An ANSI pump is much better and much easier to repair in the field. Everything about this pump is trash.