MOTOR PROTECTOR TERMINAL ?????? (ground?)

good to know...

Is this a single phase induction motor, if yes i don't see any capacitor, how does it run without capacitor?

What if the type copper wires reading are 001 and thermal shows 000

Good to know but I usually listen for the notorious sound it makes

One could also solder a jumper across the thermal break, older dryer motors do not have this safety feature to protect the motor, but if you cannot replace the thermal break and therefore have to replace the motor anyways, why protect it, you may as well just use a jumper and get on with your day and continue on with the mortor you already have.

@random5107

3 ай бұрын

Ur asking too many questions which is not good for the companies pumping money out of your pocket. Lol

i have no continuity ton the run wire, motor is dead, everything else has continuity

at times like these i wish i was an electrical engineer. this and car stuff. and house stuff. o my lord... just take me already

@repairclinic

2 ай бұрын

You got this!

No you don’t need to replace the whole motor if the overload shows open. Just replace the overload!

@alekmartin9999

6 ай бұрын

Kindly reply with steps on how this can be done

@bougatses

6 ай бұрын

@@alekmartin9999You remove it from the motor and add a new one. Check the motor’s heat fuse as well. A common open, and make sure bearings are running smooth

@dragor6527

6 ай бұрын

Just replace the motor, everyone, and thank me later. Dont get a s callback.