you are from poland???

@ErrorskiRacing

3 күн бұрын

Tak.

Hello my friend I operate a donatoni jet 625 Im having an issue with the water.. It turns off in the middle of cutting program.. And says code no water.. But when i run it manually water does not turn off. I contacted tech support and they haven't helped fix the problem.. Any advice you can give will be appreciated Thank you

@ErrorskiRacing

14 күн бұрын

Yes. What you have is a water supply sensor not getting enough pressure. There is a valve above the saw that control the water amount. If im correct you have it fully open. Please turn it down 10 degrees and then try.

@user-rz3xx2cz5u

14 күн бұрын

Thats amazing my friend I turned 10 degrees and it shut down again.. So i turned the knob a little bit more And it has not shut down.. Thank you for your help And i appreciate your videos

@ErrorskiRacing

14 күн бұрын

Do you use a reusable water?? Have you got a good filtration system?? Ive found that twitching the knob is going to far im just flushing the machine with fresh water for around 10min. Also what are the Amps that you cutting with??

@user-rz3xx2cz5u

14 күн бұрын

Yes Im using reusable water And its filtration system is new.. We just got the machine 1 month ago

@user-rz3xx2cz5u

14 күн бұрын

The amps im cutting in is like this Motor intake right now is 6.8 Ampere thershold 25 A Rpm 2198 And how often do you run fresh water for 10 minutes? So is it ok to turn down the pressure knob?