If meter console is not showing anything in Dominar 400UG and bike not starting then try tightening starter relay nuts below RH side seat cowl and remove and put back single green fuse next to it. Remove, clean and put back the socket of starter relay next to it. I had this issue. Just wanted to share with all.

Bro I too face the same issue. Every morning it takes atleast 5-7 self start to start the bike. It would be very helpful if you can help me with the ECU update version number. So that I can directly go for that update.

@00deepz

3 жыл бұрын

Sorry i didn't get the update version, usually when they connects to ecu, updates applicable will be notified.

Same problem in my avenger 160 Street bs6

Any engine noise present in your dominar

Bro same issue എന്റെ വണ്ടിക്കും ഉണ്ട്

@nandhakishor6328

2 жыл бұрын

Aente vandikkum ithe presnam und

Mileage is 31kmpl?? Wow 😎😎

fuel pump problem or feed pump problem ,not self problem.

Hi bro, എന്റെ വണ്ടി boostup ചെയിതു strt ആവാത്തത് കൊണ്ട്... ഇത് ചെയ്താൽ strtng prblm ഇനി ഉണ്ടാവാതെ നിക്കുമോ... എന്താ അഭിപ്രായം

Dear sir Meri dominaar mein fuel meter full indicate ho Raha hai

San pwde mag pa ayos nito boss manila area ako

Bro enta ecu flash cheythu oru 1 week kozhappm ilarnu veendum ingane thanne vanneka.bro update ano cheythe

@00deepz

3 ай бұрын

Software update cheythapo clear aayi

@ajithma3413

3 ай бұрын

@@00deepz eth showroom aanu koduthe ernakulam ano

How much ecu update..?

@FoxyCAMTV

Ай бұрын

2 rupees.

@abdul_basith.v

Ай бұрын

​@@FoxyCAMTV😅😅

Broo..milege oke ethreya kittunnee

@00deepz

3 жыл бұрын

28-29 kmpl in city with 91 octane petrol

Service center name location please 👍

@00deepz

2 жыл бұрын

Palarivattam

@mukeshvk6297

2 жыл бұрын

@@00deepz popular

How??

@00deepz

3 жыл бұрын

ECU update

@roninr8199

3 жыл бұрын

@@00deepz I don't think so coz even I got this issue and sometimes it starts and sometimes it doesn't. After a week time issue was completely gone.

@00deepz

3 жыл бұрын

@@roninr8199 This is basically due to program failure in reading input from temperature sensors, ECU failing to open fuel pump at required rev range so that engine temperature reaches the minimum required level to keep it from cut off. In my case it got fixed through ECU flashing followed by an update also..

@roninr8199

3 жыл бұрын

@@00deepz I have no clue. Did you experience auto reset of trip 1 and trip 2 to 0. I had lots of issue on that for my bs6 dominar 400.

@LazyTraveler

3 жыл бұрын

Same here. I don't have starting problem but getting throttle lag sometimes in 1 st and 2 gear. Not getting full power . Showroom guy said to update the ecu .