No video
DIY Radiant Floor Heating Control System with Home Assistant and Raspberry Qt
In this video I show an application of the boards I designed in previous videos (Custom Temperature Censor and Relays Box) to create a control system for my radiant floor heating. In practice, I can control the temperature of the areas of my home both remotely via Home Assistant and locally using a Raspberry-based user interface and a 7'' touch display created using the Qt framework.
Temperature sensor video:
• Esp32 Custom Temperatu...
Relays Box Video:
• Esp32 Custom Relays Bo...
Source code on
github.com/vig...
00:00 Intro
02:48 How System Works
03:41 Home Assistant Integration
04:19 Testing System
06:58 Installation
08:45 Power On
10:02 ESP32 Relays Box Programming
15:35 Raspberry Qt Application Development
Пікірлер: 25
Excellent.
Bellissimo video!!! :) grande! Provo a farlo in Python/Micro Python
Brilliant. Quick question: how are you turning the boiler/pump On? ( I see the top right toggle in the touch screen but what is it controlling)
Very interesting. What are you using for the regulation of heat source? And what room thermostat do you have? If you have one? Can you draw how this system communicates? Its interesting
Do you get a lot of temperature fluctuations in the floors with on/off controls like this? Did you consider PWM control to more precisely adjust the flow?
@vigasan
Жыл бұрын
The radiant floor has a large thermal inertia, the target temperature is controlled with a hysteresis of 0.1°C. The fluctuations are low. Sure PWM control would be better.
Dear sir I am looking at exactly what I wanted thanks and by the way can I contact you directly ?
Electrical next to water pipes?
Brilliant! I have a question: do you think your solution could also communicate with the hearing boiler and turn it off when no heating is needed?
@vigasan
Жыл бұрын
You have to see what kind of interface the boiler has. But I think it's possible.
@MaciejStachura
Жыл бұрын
@@vigasan Yes, yes, what I meant is rather if your solution allows that. The interface is quite simple "NO-COMM" or "NC-COMM".
Would you share what actuators you are using?
@vigasan
Жыл бұрын
Mohlenhoff OEM 5mm
Excellent. Will the arduino code be available ? 😁
@vigasan
Жыл бұрын
github.com/vigasan/HeatingFlowControl.git
will be great if you past a link with that board from where did you buy
@vigasan
8 ай бұрын
The board is a project that I developed.
@dutzaboss
8 ай бұрын
@@vigasan and we can't buy from some site or something?
@vigasan
8 ай бұрын
I could sell it, you can write at vigasan@outlook.it
could you make me such a relay board?
Hi Is possibile to control also cooling mode?
@vigasan
Жыл бұрын
Yes, it’s possible
Where could I get this? Is possible but it?
@vigasan
Жыл бұрын
It’s a custom board that I developed
@PabloVidalOtero
Жыл бұрын
@@vigasan I know, I know. It was in case it was possible to use the design to have it done