"DIY" HOW TO SERVICE - FORD RANGER/BT50 ( basic engine service - oil & filters)
Автокөліктер мен көлік құралдары
In this episode I show you how I do a basic engine service (engine oil and filters) on my 2015 Ford Ranger px2 will also work for the Mazda bt50 up until 2020 model
This is just a basic service to show you how to do the engine oil and filter including cabin filter, fuel filter, pre filter, catch can filter and air filter.
This Is not a major service. Any major works should be done by your licensed mechanic
*disclaimer- I am not a mechanic, these are just basic tutorials that may help you learn something for that one time you may need it!
PRODUCTS USED
OIL
www.nulon.com.au/products/die...
OIL FILTER
www.rycofilters.com.au/catalo...
FUEL FILTER
www.rycofilters.com.au/catalo...
AIR FILTER
www.rycofilters.com.au/catalo...
PRE FUEL FILTER
www.rycofilters.com.au/catalo...
CRANKCASE / CATCH CAN FILTER
www.rycofilters.com.au/catalo...
CABIN FILTER
www.rycofilters.com.au/catalo...
AIR FILTER CLEANING PROCESS
• How to clean your air ...
CATCH CAN AND FUEL FILTER INSTALL
• DIY * Ryco Fuel Filter...
To support the channel head to
azventuresaustralia.com
Follow me on:
/ azventures_australia
azventuresau...
Пікірлер: 45
A replacement oil filter housing costs around $35 and means you can remove and refit the filter in less than a minute. You will then always have a spare filter housing for all future oil and filter changes. Reduces the whole process down to around 5 minutes.
@Angler233
4 ай бұрын
So the 10 min operation includes the time it takes to change the filter? How does that affect the oil pump?
@xj358
4 ай бұрын
@@Angler233 Yes mate, you can do the whole lot in 5 minutes if you're ready to go with everything. That's filter off and on(60 seconds ). Old oil out and sump nut refitted (90 seconds). New oil in (90 seconds) and then fire up the engine. Supposedly, if you take longer than 10 to 15 minutes to refill the engine oil on a Ranger 2.2 and 3.2, then it drains from the oil pump and will not then prime itself when you start up the vehicle leaving you with no oil pressure. I therefore don't want to get close to the 10 to 15 minute mark so I get it done around the 5 minute mark and haven't had any problems.
Been looking for a Ranger KZreadr. Great stuff. Feeling inspired with the oil change now.
Very good videos mate. Thank you for your effort for making such informative videos. I replace my BT-50 CV referencing your video. Great stuff.
taking a pic before disconnecting the lines is a good idea. We don't always need "before" and "after" to be different
Thanks for that Azza! You have inspired me to do my own servicing. Used to service my previous 4wd but was worried with the rangers about the oil pump and the 15 minute time. But definitely more confident seeing this video. Cheers mate 👌
22:06 I like those ramps for maintenance.
Thanks buddy, feeling a lot more confident doing this after watching your vid. Cheers.
Legend! Clear concise and quality audio and video.
Thanks mate you’re a legend I really wasn’t sure about doing a proper service to my 2015 ranger!! Because I wanted to save money and your video was very detailed !! I’m gonna do my own service this week!! Thanks for sharing
@AzventuresAustralia
2 жыл бұрын
Appreciate the feedback mate!!!! You can definitely save a few bucks and also learn a heap about your car mate🤘🤘 rip in
Watched loads this best planed oil and filter change
Thank you heaps, very helpful video. 👍
Bang on 👌🏽
Bro this was wicked info I do all myself Exept the Engine Oil , AZZA so do the oil filter , 1st ✔ replace with new, & time don't start until the sump plug is off ,
That's awesome, thankyou
Good job
Great video mate, love number 2 on ya shed not to do shed rules list.
@AzventuresAustralia
2 жыл бұрын
🤣🤣🤣 the best rule on there
@AzventuresAustralia
2 жыл бұрын
And probably just good life advice I reckon 👊🏻👊🏻
Good man👍
Hey man definitely recommend using bit better oil I use 5w 30 Penrite full zinc oil always used that good shit, I’ve got a px1 ranger an px2 my px1 it has just ticked over to 500 000 thousand kms still going hard my px2 has 94 thousand kms an use the same stuff I’ve never had a motor problem I do the oil changes every 5 thousand kms cause I’m hard on the gear mostly haha. Just a recommendation man🤙🏼
Thank you
Awesome bro than you
Hey mate thanx for the vid i have the exact same vehicle even dow to the colour this was very helpful how do we reset the service light?
Epic Service mate ,,, on the oil drain , last time stamp you gave was 1:30 min would you say it was a 2:00mins drain total ?? , also you seemed to rush refill and start up , is the rushed start up a necessity in relation to the Pump ? Or just you showing how swift it can be done within 10mins Hope my ocd comment made sense
Hi mate, replacing the oil filter is included in 10 minutes window in changing the oil and filling up new oil? or the 10 minutes window is just only for changing the oil and filling up new oil?
When you do the engine flush and run engine to normal temperature can u change oil straight away and still have the 10 mins window or will the oil drain out alot faster bringing the 10 minute window lower?
Don’t drain oil first but change oil filter and then drain and fill out quickly
Why didn’t you remove the oil filter through the wheel arch?
Fair play mate
Have you added anything in between the loam under that rubs on the timing cover
Forgot to ask, as you changed filter first, does the 10 mins start after that
Fair play bud, I did mine for the first time this Friday gone, and had watched other vids as well, some talk about taking off sump guard…..tosh, I did and found no need to but found out previous dude put it back, ass about face[that’s another story😅, ] but other guys had me washing off components with degreaser and rags galore before re-assembly and I was basically under the cosh right through😢, and yeah oil Shit in abundance, but you didn’t give a fuck, one out one in bosh!! Fire it back together and March on brother, wish I’d seen your vid 1st 😂😂😂
I got a 2017 model ford ranger is everything the same? Im learning to do this myself as its hard to find a mechanic who wont rip me off
Have you got a tune with EGR sorted to stop soot?
Use the cloth or paper towel to make an imprint of dipstick level the oil will show up easier on the towel then trying to see it on dipstick
I use a 10L measuring jug from bunnings to top my oil up I just pre fill the jug to 4.5L and pour it in, abit easier than holding a 10L drum and guessing.. it also speeds up the oil change aswell if your really concerned about the 15min time limit. just a tip for all those out there
@braydenfletcher5089
2 жыл бұрын
The rangers take 9.8L of oil so it’s pretty much the whole drum anyway
@offgrid4x481
2 жыл бұрын
@@braydenfletcher5089 your correct if you were to suck every last bit of oil out, but the oil pump plus some lines do not completely drain therefore it will never be a complete 9.8L replaced, i usually have 1.5 - 2L still in the 10L drum afterwards
Is the 2012 ranger the same
Why did u change the fuel filter with it in car and not take whole thing out?
That was a very well deserved beer! I'm planning to service my 2016 Mazda BT-50 at home and this video helps a lot. Just curious about the fuel pre-filters, I am not sure I've ever seen those in my car. Will go check now. Thanks for the video!
I don’t understand why people drink mid strength beers? If ya gonna get on the piss rip in