DIY how to make a compact mini leather wallet - PDF Pattern
Red waxed leather, with its distinctive surface, brings understated style to the simple but practical design of the mini wallet. Three card slots, one compartment for bills make it functional. This mini wallet is small enough to fit into all pockets! Dimension: 7.8 x 11 cm
Grab the Pdf Pattern here:
www.etsy.com/listing/1326918831
#miniwalletpattern#pdfwalletpattern#leatherpatternpdf#walletpatterns#walletpatternpdf#wallettemplate
Пікірлер: 23
Very freaking cool! Well done!
Did you use any sticking glue before stitching the leather pieces? if yes, which glue?
Linda!!
That is some of the most beautiful leather I have ever seen. What is the thickness and where did you get it?
i dig this
@cassivintage
Жыл бұрын
Thank you 😍
@EthanDyer
Жыл бұрын
@@cassivintage of course a vary practical unique and well made wallet
boa noite, poderia me informar a largura dos bolsos para cartões? Preciso saber se caberia uma carteira de identidade de 9 cm de altura x 6,8 cm de largura?
Good evening, could you tell me the width of the card pockets? I need to know if a 9cm high x 6.8cm wide ID card would fit?
@cassivintage
Жыл бұрын
Hi Antonio, sorry for the time zone difference that now we just can reply your message. The dimension of the mentioned design is 7.5 cm width , 10.5 cm length when rolled. The card slot inside can hold cards with 5.5 x 8.5 cm. For the ID card you said, we have an only choice for it, which means the card slot on the back of the wallet,its width is 7.5 so your card can fit there.
Nice. What kind of leather is that. Very creative design. I use rare earth magnets in a wallet I make and man are they powerful.
@cassivintage
Жыл бұрын
Hi there, FYI we used waxed cowhide leather
Good job!!! But what about magnet on bifolder and magnet stripe on card?
@cassivintage
Жыл бұрын
Good idea sir, we'll think about that ^^
You cut by laser ??
шикарный кошелек, но выкройку никак не взять, что то ее блокирует ((
@alexbuxus
9 ай бұрын
ВПН попробуйте, 12 ойро
Hello, could you tell me the thickness of the leather you used?
@cassivintage
Жыл бұрын
Hi there, FYI we used 1.2 mm thickness, but there arre some parts of the wallet you should make it thinner like the part with the magnets we used only 0.5mm thickness
@andris3669
Жыл бұрын
@@cassivintage Okay, thanks a lot!
Check out a bit larger and an extended version of this wallet I made - kzread.info/dash/bejne/hIF2w86ac8a0f5s.html
Hello sir wollet price
@cassivintage
Жыл бұрын
hi there, so sorry because we sell pdf pattern to make the wallet, not selling the wallet.