DIY E67 Bench Harness - save at least $100
Where to find the info and how to do it
www.customecm.com/bench-harne... Great website for the pinouts and the wiring of the power box. Use the link that says "bench harness" at the top. There are links for all of the supplies he used on the site also if you want to go specifically off of his build.
Michigan Motorsports OBD 2 port. amzn.to/3M7jSit
Good quality silicone insulated wire. amzn.to/3FnEf7n
Project box. amzn.to/3FpL1cK
Switches amzn.to/45CCfTl
Crescent side cutter/plier set amzn.to/48Xq3j4
Irwin Automatic Wire Strippers amzn.to/3S8iIXU
When you get tired of junk soldering irons, buy a Hakko!
amzn.to/3rNJ8ni
Пікірлер: 4
Very nice😊
Hey Dean thanks for the info... I built one and it isn't able to read the E67... Can you confirm that you have the 2 can buss wires going the grey plug pins 53 (High) and 33 (Low).. Also 3 wires to the blue plug pin 19 is 12v ignition, pin 20 is 12v constant and pin 36 is ground... And no wires to the black plug... Do you have any wires other than the 5 mentioned connected... Thanks... Mark
@deansmessygarage8616
Жыл бұрын
Hi Mark. Mine is wired exactly as the diagram on customecm.com and it's as you said. No extra wires. I'm not sure if you used the same switches I did, but I do have to hold the intermittent switch while it's reading.
@markd4838
Жыл бұрын
@@deansmessygarage8616 Hi Dean... Thanks for your reply... I think I have mine working now but have not tried to flash my ECM yet.. I guess there is more than one way to pin the E67's... Thanks again... M