You have your own way of doing things. It’s called “the right way.” Bravo.

@normalguydoesitall

4 ай бұрын

Sometimes doing it yourself is worth it and your heart is satisfied when you have done something awesome, this time it is. Thank you!

Nice addition to the garage! Take care & stay safe

@normalguydoesitall

4 ай бұрын

Thank you!

Add heat exchanger pipe to top AND bottom of your manifold. Doubles your heating surface. Very nice installation. Like the way you continued the exhaust to the stove pipe.

@normalguydoesitall

4 ай бұрын

Thank you! there are still many ways to get warm from there i know. All the pest to you!

Great idea, could you use a water type radiator it would have more surface to air ??

@normalguydoesitall

4 ай бұрын

yes, I know that, but I wanted something on my garage wall that was made by me and would look more awesome. Thank you!

Nice job💪💪

@normalguydoesitall

4 ай бұрын

Thank you!

Great bro! But please get a carbon monoxide alarm in there also!

@normalguydoesitall

4 ай бұрын

good idea but i don't usually stay that long and the room is ventilated and the doors move all the time so fresh air moves. Thank you!

Hello from the Netherlands. thanks for the video. Kind regards, Hollandduck

@normalguydoesitall

4 ай бұрын

Thank you!

Wszystko ładnie, pięknie błąd jest tylko w wydechu. Rurka od niego i cały radiator powiny iść w dół żeby nie gromadziły się w nich skropliny.

@normalguydoesitall

3 ай бұрын

w moim wydechu nie ma kondensacji, konstrukcja jest prawidłowa. Jeśli używasz grzejnika, którego wejście znajduje się na górze, a wyjście na dole, nastąpi kondensacja. dziękuję bardzo i przepraszam za tłumaczenie Google

I used an Old 150cm Towel-Radiator leftover from my Bath Restoration. I simple changed the Caps/Valves on it. I go in the Radiator on the lower side Left and out upper side Right. After the first few (too short) tests i saw Drops/dripping on the Exhaustpipe/Inlet where Condsensation was gathering. Then i tilted the whole Radiator a tiny bit to the Right and took a "Airbleeding" Screw to the lower right, to drain the/some Condensation. So far if i checked there was none. Maybe now i let it run long enough to heat/steam it out.

@normalguydoesitall

4 ай бұрын

Yes, there are several options, I wanted to make something cool and original in my garage. I haven't realized that condensation would occur, I've also opened the pipes, I think it evaporates because the heating usually works for a few hours. Thank you!

Next one --FIND AN OLD CAST IRON RADIATOR AND TRY THAT...HMMM

@normalguydoesitall

3 ай бұрын

OMG. I know that, but I prefer something nicer on my garage wall that I have made myself. Thank you!

Where do the condensation wather go??

@normalguydoesitall

4 ай бұрын

Hey, I don't know that I haven't seen it yet, the heating usually works for several hours, I think it evaporates. Thank you!

💖

Päris palju teeb vist müra. Pigem sobibki ruumi kus ise ei toimeta eriti?

@normalguydoesitall

4 ай бұрын

Video võimendab seda müra natukene, garaazis toimetades ei saa arugi et ta töötab. Garaaz ei ole koht ju kuhu vaikust nautima minna😉. Suur tänu!

Oled sa Eestis? Hästi tehtud

@normalguydoesitall

4 ай бұрын

Suur tänu, ikka Eestis😉

They're just hideously noisy though who wants that constant whining noise inside ? Not me!

@normalguydoesitall

4 ай бұрын

Hey, yes, they are loud devices, but nothing bad, and the video makes the noise worse. Besides, I don't go to the workshop to enjoy the silence, if I'm working, the noise doesn't bother me. Thank you!