No video
DIY 2023 Ford Bronco Fake Subwoofer Upgrade
In this 2023 Ford Bronco we installed a Kicker KEY 500.1 Amplifier with gain setup and bass revealer/processor built in. We also installed a Kicker CompRT 48CWRT672 6.75" subwoofer in the factory location. When run at 4 ohms the amplifire puts out 125Wx1 so we have also made a harness that allows you to use all the factory wiring for signal and power. Check out the web site to order. shop.enfigcars...
Пікірлер: 70
Hey Enfig, I purchased your kit after watching this video a week or two ago. It showed up today and I was able to put everything in with no problems! I didn't even break a clip LOL. I really appreciate the detail and step by step process you show here, it helped my amateur ass a ton and I just wanted to say I truly appreciate your work. After swapping out the rear pods and dash speakers, this is exactly what my truck needed. Thank you!!
@Enfig
5 ай бұрын
I"m glad the install went well. Its not hard at all with a little guidance.
Thank you!!! Bought the whole kit from you in December and did the install on my wife's 2-door 2023 - I was very close to buying a tailgate mounted sub before I even learned about the dummy amp and speaker, glad I found this option instead. This isn't window rattling bass by any means, but going from what was essentially zero bass to this was a huge improvement.
@Enfig
6 ай бұрын
Glad to hear. It does sound really good considering it's a small sub.
Hey chris,Im going to watch t the video when im laid up in the hospital on monday. When you gwve me the car back there was no sign that you took it all apart. A real clean professional job. I need to play with the bass knob and the radio settings to find the right spot . I will say this the truck Soundsystem really has some depth to it. That sub made all the diffrence .im looking forward to our next project, changing over the rear pods from 4" to 6". . Im lucky to have found you. I will post an update when i have had time to play with it further. Regards Angelo ( anthony) lol
@Enfig
9 ай бұрын
Good luck with the surgery. I'll be waiting to finish her up when you're ready.
So I watched the vid.Let me say you sir,are a genius.so many people are spending big money on tailgate mount subwoofer,or a big box tHat takes up trunk space. You found a way to put the woofer in without any sacrafice to space.Y our video was extremely thorough. Every potential problem and its solution was addressed.I must say i was glad to be your Guinea pig!. The safe was a ford safe from ford accessories ( outlet).the seatbacks were mabett.and my buddy did the research,the dummu amp and speaker had to be put in so when they did thr crash test it was closer to the vehicle weight of the test car. Thanks ,im very happy the way the finished product turned out .I will be reaching out soon for the rear pods. Angelo
@Enfig
9 ай бұрын
Tanks Angeo! Hope you're back on your feet soon!
Good vid bro even enjoyed the parts of you thinking out loud believe it or not some of what you said helps more than just doing it with edits glad to have run into your channel very informative best of luck to you
@Enfig
3 ай бұрын
Thanks I really appreciate that.
Thank you. Worked great.
@Enfig
4 ай бұрын
Glad to hear
He says be glad it’s a new car and not a 30 yr old car, you can still get parts for it ! Yeah, you can tell for sure it’s the first Bronco he’s worked on! 😂 . You can get parts, you might just have to wait forever.
@Enfig
26 күн бұрын
lol I've been looking for seats for my 2005 A4 convertible for years. Broncos might have a backlog but they will eventually be available.
26:15 they install the dummy amp and sub for a very good reason. This allows for the line workers to follow the same assembly procedure no matter if the bronco has the option or not. It would require a line assembly change and that was too costly vs just installing a dummy part. Line workers time is very carefully allocated and choregraphed. A deviation in that is a big deal to a mfring line. Thats assuming there is also no tooling change. That would add 10x to the cost.
@Enfig
3 ай бұрын
Interesting
Was looking on the site notice it don’t have any for 2018 Volvo s90 t6 inscriptions
You a good teacher!
@enigmavariations3809
7 ай бұрын
Unlike your English teacher.
@Enfig
7 ай бұрын
Thank you.
@Enfig
7 ай бұрын
Be nice. English isn't everyone's first language.
I see is Ford attempting to do owners an option to add an amplifier and a subwoofer in the most effective way, given the lack of parts to have it included from the factory. The good news about this enclosure and a placeholder for the amplifier and an aftermarket speaker is that you don’t have to fabricate one from scratch. I have seen other videos where an included BNO sub-woofer had to be modified to accommodate an aftermarket speaker however, in this case, the aftermarket speaker fit the enclosure without modification.
@Enfig
3 ай бұрын
This is the firs time I have heard of ford offering a solution.
I'm not sure about hanging cables vs resting cables on the amp. Cables end up touching the amp and heat rises. Probably best to let them hang or secure to the car body, but always below it.
@Enfig
4 ай бұрын
While I agree it will not get hot enough to my cables.
Do You sell Just the harness already installed the kicker sub and tried a fusion amp it works just not enough bass
@Enfig
5 ай бұрын
Eventually we will sell the harness by itself for a higher price because there is demand for it. We need to catch up on backorders first.
Very good tutorial.. But I feel like that tiny sub with that few of watts in a loud Bronco would be a waste of time 😅
@Enfig
3 ай бұрын
Depends on what you want. But its sound much better than you would expect from a 6.75" speaker. If you are comparing it to a 12" sub hanging off your rear door with 500W going to it this is not what this is. But this is much better than OEM whiteout losing any trunk space.
I am really close to pulling the trigger on this kit. My question is, the kit mentions that a wiring harness is included in the kit. But I also see the wiring harness sold separately. I have the non B/O system with the (real) functioning amp and sub from the factory. Will I need the additional 99.00 harness?
@Enfig
21 күн бұрын
The kit includes the harness. We sell the harness separately because some people find our video after they have purchased the amp and speakers. We give a package discount when everything is purchased from us.
Isn't the stock harness too small for the sub? I thought this sub would require an 8 gauge wire for power.
@Enfig
29 күн бұрын
Not at all. The amp can do 500W when used with a 1 ohm sub. That does require an 8ga wire. When used with the 4 ohm sub it's only at 150W and the factory wire is enough for that. The engineers at Ford put a fuse in the car to protect the factory amp power wire. If the amp was drawing more than that cable could handle the fuse would blow. And if the amp wasn't getting enough power it would go into protection. I'm overly cautious about everything I sell and I can guarantee the wire is fine. I've sold over 100 kits with no issues.
@saslumpff
28 күн бұрын
@@Enfig Thank you
What is the actual benefit of having the bass knob? Can you not just adjust the bass from the screen? I have 0 experience with car audio but if the amp is rated for 500 watts, and the sub is rated for 300, is the limitation only the factory power wires? Could you just run larger wires directly from the battery and get 300 watts out of the same setup?
@Enfig
3 ай бұрын
With extra bass you sometimes want to lower the bass on songs that are bass heavy. Also sometimes you want to blast your music and other times you want to listen with very little bass. Of is your'e listening to talk radio you don't want the bass hitting. The bass on the radio affects all the speakers. You might not want to lower the mid bass of the speakers. The bass knob is a volume knob for the sub only. The factory power wire cannot handle more power. I also have a feeling if you put too much power to the sub the plastic panel is going to rattle but do research and see if anyone else has done that upgrade. But more importantly ask if they listem to the bass at full volume or do they drive around with the bass knob at 1/2 way.
Hi Enfig, I have 2022 wildtrak with a pocket panel instead a subwoof panel. If i purchase your kit, will it work? My doesnt come with subwoofer.
@Enfig
29 күн бұрын
I honestly don't know if that car has the wiring for the sub. You would at least need to buy the enclosure.
Informative but could be much shorter if you cover only what is needed and edited out the dead space.
@Enfig
4 ай бұрын
I plan on making another video. That was only the 2nd time I had done the installation. It’s hard to film just what’s needed when you’re not super familiar with the car.
Ford put in a phony sub for crash test reasons. If it had an actual magnet and voice coil, it could have been a decent 6.75-inch sub. A 1998 Mercury Mountaineer had an 8-inch Mach subwoofer in an identical location probably around 100 to 150 watts. It bumps for a factory sub and can hear the bass even if all the windows are down at highway speed. Sure beats the new B&O system with its sorry little sub that would be great in a small car like a Chevrolet Cruze but, not fit for a topless 4X4 SUV.
@Enfig
20 күн бұрын
Crash test reasons makes sense. The kicker sub Hits pretty nice. I'm not sure how it compares to the B&O but I assume its better.
Thanks for the video. Wish I had your skills and experience. Do you know if this set up will work on a 2022 2 door, non-BO? I think I can order the sub box from Ford if it fits in a 2 door and go with your set up. I'll have to figure out wiring from sub to system and power.
@Enfig
9 ай бұрын
I don't know that anwer yet. If you are local give me a call. But eventually we will have a kit for all broncos including ones that did not come with sub boxes.
My amp will only work with the input button on the kicker key 500.1 button out. Is this normal?
@Enfig
4 ай бұрын
Are you using my pnp harness?
Does the bass still work with the top off the bronco? My sound guy said it will sound terrible with the top and doors off.
@Enfig
6 ай бұрын
I cant answer that but you lose bass in any vehicle when the top is down. That's also an opinion depending on how much bass you need. I have a 13.5" sut with 600W going to it in my car so that's a different level. . If you have installed it please chime in with your opinion.
My 2023 bronco came with an operational amp and sub, which I swapped out for the kicker key 500.1 and a 6.75" kicker sub. I'm getting very minimal sound out of the new sub, any idea why?
@Enfig
2 ай бұрын
Did you program the amp?
@johnpousson781
2 ай бұрын
@@Enfigyes I ran through the kicker setup. It's working, just hardly putting out any sound.
@Enfig
2 ай бұрын
@@johnpousson781 Did you use the -10DB files?
Hi there will that wire adapter work on a 2019 ford f150
@Enfig
5 ай бұрын
I can make one but since I specialise in german cars nobody has brought me an F150 to make one.
Will this work for the 2024 model
@Enfig
5 ай бұрын
I have not verified it but if the 2024 has the sub box and wiring it should work.
What’s that harness called ??
@Enfig
7 ай бұрын
We sell the kit on our website.
Dude, you really talk way too much. You want to get on with the job first you spend all this time talking about how to put stuff in place then you have to lift it all off anyway to get out everything.
@Enfig
4 ай бұрын
I'm a talker. That's how I do my videos. I explain step by step and throw in some of what I think is entertainment. You can always just lower the volume.
-250 goes back to your taxes
@Enfig
6 ай бұрын
That interesting
This guy does not inspire confidence, just figuring it out as he goes breaking stuff along the way. Probably should not break his own rule of not videoing the first removal.
@Enfig
Ай бұрын
What did I break? (Plural?) Please let me know so I can edit it out next time. There is nothing better than a super edited video that makes the job look super easy and gives you no information.
😂 2023 and we get fake speakers in a newly purchased mini van😂😂
@Enfig
5 ай бұрын
Thats a nice minivan
Great video! Very informative! My local dealerships and installers have no clue about this Forscan update. Most of the people of talked to are acting like I have no clue what I’m talking about when I ask if they can make the changes for me. Where did you find the info on where to make changes and what to change them to??
@Enfig
3 ай бұрын
I just searched around the forums. Once you get enough people saying the same thing its usually pretty reliable.