Dewalt AMF radial arm saw bearing replacement #2
Тәжірибелік нұсқаулар және стиль
2nd in a series on bearing replacement in the AMF dewalt RAS
sorry for the short shotty videos but dont have a good video editor, if I get one later I will combine all of them into one video
hope this helps
Пікірлер: 8
Steve! I am rebuilding my Dewalt 925 and really needed the information in your videos! Thanks for making this series of videos and sharing your expertise!
@madebysteve1738
4 жыл бұрын
no problem,,,glad it helped,,
This is an induction motor, not a universal motor. Induction motors do not have brushes. Drills, grinders, etc have universal motors and you can see the sparks from the brushes in some of the tools.
Steve, this is just the video I was hoping to find on here. Where did you source your bearings from? Also, do you happen to have a line on any other spare parts? I'm after a key switch (on the arm). Great, stuff. Thanks for this!
Is it possible to repack the bearings or are they sealed up pretty good?
@madebysteve1738
4 жыл бұрын
the are a sealed unit,, they are readily available at a low cost,,,
is the person in this video who changed the bearings, still active on this channel? i followed his instruction but I can not get the bearing to seat in the motor housing cap. This is preventing complete closing the motor housing. Assistance would be greatly appreciated. Keith
@madebysteve1738
Жыл бұрын
yes I are,, do you have some dial calipers to check the sizing?? mine went in pretty easily,, check for bumps or deformations on the housing,,