Development Junction flat pattern in Solidworks Sheet Metal
This Video Demonstrates the Junction Flat-Pattern Capabilities of Solidworks Sheet Metal
Жүктеу.....
Пікірлер: 14
@miguelmoreno68658 ай бұрын
Lo mejor con diferencia que he visto en KZread. Muchas gracias porque el mundo hispano pese a sus 600.000.000 hispanohablantes apenas hay gente cualificada y generosa como es tu caso. Hay mucha gente pobre que necesita y quiere aprender y no puede.
@macelwilliams69618 жыл бұрын
I appreciate your work
@rayannsun155310 жыл бұрын
thanks! very helpful!
@skarestars99058 жыл бұрын
muito bom , gostei vou aproveitar bastante suas aulas obrigado!
@mkindustries78159 жыл бұрын
good work
@kishorpanja73478 жыл бұрын
Sir. Thanks for your valuable post on youtube.I want to know, how rotary air lock main body joint development will done in solid works.
@Mr.Snow128 ай бұрын
If you are reading this comment please reply. Can you tell me when I flatten my pipe and export the cope file to dxf, the measurement is not correct. The pipe in real life is bigger than my cope template by about half inch. What setting would I need to change in solidworks to get the same size template that would work on a real pipe of the same size
@macelwilliams69618 жыл бұрын
can you develop a cone with a 90 pipe intersection and pipe with square pipe intersection as well as a square pipe with a round pipe intersection please
Пікірлер: 14
Lo mejor con diferencia que he visto en KZread. Muchas gracias porque el mundo hispano pese a sus 600.000.000 hispanohablantes apenas hay gente cualificada y generosa como es tu caso. Hay mucha gente pobre que necesita y quiere aprender y no puede.
I appreciate your work
thanks! very helpful!
muito bom , gostei vou aproveitar bastante suas aulas obrigado!
good work
Sir. Thanks for your valuable post on youtube.I want to know, how rotary air lock main body joint development will done in solid works.
If you are reading this comment please reply. Can you tell me when I flatten my pipe and export the cope file to dxf, the measurement is not correct. The pipe in real life is bigger than my cope template by about half inch. What setting would I need to change in solidworks to get the same size template that would work on a real pipe of the same size
can you develop a cone with a 90 pipe intersection and pipe with square pipe intersection as well as a square pipe with a round pipe intersection please
@CALearnings
7 жыл бұрын
kzread.info/dash/bejne/pmaGo9mJqKezlZc.html
Is it applicable for other than 45° angle?
@mihaibr206da
3 жыл бұрын
yes.you cam make this for any angle.
with conical please same 45 degrees
intersections are not perfect