That was very useful thank you!

Explanation way is very good👍👍👍

Hi, very knowledgeable and helpful videos.can u pls make videos on types of glass used in glazing works and aluminum sections also.

Wow it is nice and clear lecture keep it up!!!!

The width of landing should be equal to the width of the flight. ( Minimum ) Also, i would recommend that you should design the staircase first and allocate space required as per floor height first... Would not recommend trying to "fit" in a staircase in a pre_defined space as mentioned in your video. Also, the width of the flight is dependent on the building type. Development Control Regulations have to be referred to to check if the staircase is as per regulations.

Thanks a lot Very useful Can you please upload the video for beam and column load calculation Beam and column design for a building construction Please Please

Which design is space effective ?

Thanks, so helpful

Nice sir, but highly technical

The video is helpfull for revise purpose...but those who are new one ,lack of concept,for them need more explaination & slow teaching...unless they can understand properly

sir what if the nmber of risers has a value of decimals? like mine i have a value of 11.67, should my no. of risers be 11?

Nice

Tq sir

What is lobby in stair case?

Plz design 3 nos a staire case

Excuse me can you tell me when you get tread standard that say it shall not be less 220 mm, because I design stair that i should put 230 mm for tread, because that i want to prove that my tread is enough, and not small, that why i want to know where you get that standard that say it is ok minimum of tread 220 mm.

For length of flight u can't take 2.25 it's wrong it varies

U can't get the 4.5m by adding all the dimensions pls check once

Who the fuck click unlike bottom....