Depron and Modelling Foam Building Techniques
Ойын-сауық
How to work with Depron and Modelling Foam. This video briefly explains the following topics.
1. Tracing Parts to Sheets
2. Cutting Depron
3. Undercutting Surfaces
4. Attaching Control Surfaces
5. Sanding Depron
6. Gluing Depron
7. Bending and Forming
8. Decorating
Depron and Modelling foam sheets are available on our website - micronwings.com/Products/Sect...
Пікірлер: 23
6:35 You're the man! This tip saved my day! Thank you!!
I'm about to build my first Depron plane and this gave me some good pointers - thanks
Great Video ! There is another way to transform your Paper Plan to the Depron: Glue it directly on it with a small amount of spray glue or a gluestick. You can easyly peel it off when you are done with cutting. Bending Depron is also possible by using the Edge of a Table: Just pull it gently over the edge - over and over again and put your hands on top of the Depron piece while doing it. it will bend in the directiom of the table edge. I hope you got me, my english language skills are not on point.
Great tips We’re always told never use a metal rule and a sharp blade because it runs across metal . Always use a wooden one where it digs in.
Nice video. Very helpful 👍👌❤️
Great tips thanks a lot.
Excelent video. Your parts almost look like laser cut parts.
1:40 Dont always change the blades like that, the chances of the fresh blade in cutting your finger is high. I had an experience in which I cutted my nerve in the left thumb, so much blood was lost. In my case the blade was not on any table or something, just on my hand, but always be careful. Edit : spelling mistake
Very helpful
Josss banget
grat video..LIKE.... please,is a 2mm thick depron slightly translucent or not ?
@MicronWings
2 жыл бұрын
No the 2mm is not translucent at all.
my god that marker looks like a mini cannon
Is depron the type of foam which is kinda plasticy and sometimes used in packaging?
@MicronWings
4 жыл бұрын
It is constructed from individual closed cells of polystyrene plastic
💖
Can I use hotglue ?? UHU glue seems to be pricey
@MicronWings
2 жыл бұрын
Hot glue will glue foam but the problem is that it will also melt the foam. It's not really a solution.
@crashtestrc4446
2 жыл бұрын
@@MicronWings hey I actually used hot glue and it came wonderfully kzread.info/dash/bejne/Zpucr9yGZ6bZhdI.html
@MicronWings
2 жыл бұрын
@@crashtestrc4446 Yes Hot glue will work too. But if it is too hot it will melt the foam when you apply it.
@crashtestrc4446
2 жыл бұрын
@@MicronWings yes I kept a scrap piece of depron to test out the right heat for the depron