Good job and nice filming.

This is the video I’m going to use for my 1983 Ford bronco, thank you so much

@CarolinaMedia

7 ай бұрын

Glad it helped. Thanks for watching!

Beautifully done!

@CarolinaMedia

2 ай бұрын

Thank you!

Nice job. That wil help when I attack my 1996 4x4's front wheel bearings.

@CarolinaMedia

11 ай бұрын

Thanks jftuser! Your 96 might have slightly different calipers.

Great job!

“Great video! 😃 I have a 1981 F-150. Are the bearings the same? Also, do you have the seal number? Thank you very much.”

@CarolinaMedia

5 ай бұрын

Yes. If you have a Dana 44 the bearings will be the same. I like Timken bearings: Set 45 and set 37. The seal part number for Timken is 4250. Amazon sells it for $6 Thanks for the feedback!

15 lb/ft is way too much for the inner nut. Torque it down to seat bearings, back off and basically just hand tighten or ever so slightly more with new bearings. When you do the final torque on the outer lock nut it actually preload the inner nut even more. You'll find the rotor very hard to spin by hand if not done correctly and bearings will burn up quick

@CarolinaMedia

3 ай бұрын

Thanks for the feedback.