Dads Shed 11 - finish turning of the Vertical Head main spindle.
Ғылым және технология
The next stage of the vertical head - the finish turning of the outside of the spindle to take the bearings.
Turned using an INT 30 fixture to ensure the bearing sits on a surface concentric to the taper in the spindle bore
Пікірлер: 9
Really enjoyed your video
@DadsShed-om4lz
6 ай бұрын
Many thanks!! It was great to get back out to the shed again!!
Hey Dad aren't safety glasses overkill, versus a safety monocle. I hear there half price. Can you order one contact? Sorry but the Elephant in the room made me say it. Excellent job.
@DadsShed-om4lz
6 ай бұрын
Safety monocles are horrendously expensive - I've had my eye open for them for some time........ Plus the parrot much prefers the glasses!!
@stewartfrye
6 ай бұрын
Damn, I forgot about the parrot, good point @@DadsShed-om4lz
My instructor would have banned me from the shop for all that swarf on the chuck
@DadsShed-om4lz
6 ай бұрын
don't blame him! I thought I cleaned it away, but brain fade meant I'd only pushed it down and a single stray piece picked it all up!! Made me jump a bit I can assure you. But, it was so tightly wound around the chuck jaws it wasn't moving so I waited until I'd finished the last few cuts to clear it out with pliers!
Hell of a rat's nest you've got there.
@DadsShed-om4lz
6 ай бұрын
Yes, reminder to actually clear all the ribbons of swarf when working near the 4 jaw!!