I thin your water supply method is one of the best DYIs I’ve seen in years. Great job.

Experienced saw user here. You made this look too easy! I've been using a nearly identical method over the last few days, and it didn't go nearly as well. After several cuts, I'm pretty sure now that my blade was bad. I had to take the 1.25" slab in three cuts, and even still, the deck lifted and the motor strained at a snail's pace. I also think that the saw I used held the blade so that it was not perfectly parallel to the fence, and so my last cut ended up going off nearly an eighth. If I were to advise somebody starting out, it's this: 1) buy a brand-new blade, and 2) make sure your saw's blade is running perfectly parallel to its sole's edge.

Loved the water siphon trick! Brilliant!

The brake line was literally all I was missing. Trying manage the tubing while safely controlling the saw stressed me out enough that I hadn’t tackled this yet. Thanks for the brilliant tip!

Thank you you explained exactly what I needed to know.

A little tip put painters tape where you gonna may that cut the help not chip the granite

Thanks for your video, that is pretty much exactly what I was thinking of doing too! I have to cut a much thinner piece of ceramic tile but it's 4' x 2'. Adapting my Skilsaw to do this work is a key feature that doesn't break the bank on a specialty tool that I'll only use a couple of times!

THANK YOU!! Extremely helpful and well done.

It was pure satisfaction watching your video. So simple yet so brilliant.

Really clever..thanks for posting!

Excellent video! Well done 👍

Great video, and a great job. Thanks

great video, I got a piece of granite to cut , mine wasn't free but, I had some questions about the blade to use and how I would set up the water supply, and your DIY video has really helped , informative and got to the point, Thank you

Two things:

This was pretty cool

Great idea well implemented. I just bought an electric plant mister ($20) to do the continuous spraying but may return it and go this route instead.

Brilliant!!! thank you

Nice hack. Another thing that you can do, is to take a hot glue gun and create a little channel around the area to be cut that will hold water in it. I do this for glass drilling as well.

Good job sir

Holy Lick... Thankyou thankyou thankyou... this is exactly what i need.. I'm basically "Ignorant" zero experience whatsoever, was planning to use and angle grinder,, Not A Chance In Hell after seeing this video... Helpful? Extremely ... probably saved me injury and a trip to the emergency.