CPC4 Fault Code for Cascadia Freightliner : Automatic Gear Selection/Gearshift Not Plausible Code
Ғылым және технология
The guy in the video talks about warranties and returns and missing codes in the parameters. The particular code discussed in this video is the automatic gear selection/gearshift not plausible. Missing codes in the parameters are usually caused by a bad upload from a dealer.
This unit was returned throwing this particular code so our particular parameters for our truck were installed and it was taken for a test drive. As shown in the video the unit performs flawlessly.
Thanks for watching the video and please subscribe to ERD TV for more CPC4 updates.
Visit www.wefixcpc4.com for more information.
Join the over 2000 satisfied customers at wefixcpc4.com, where we have a 99.5% track record with CPC4 repairs.
Go to erd-powertrain.com for our anti-theft quick release cord, making it easier for you to safely install and remove your CPC4 with having to worry.
To find all of ERD Ltd Inc. repair capabilities go to www.Industrialrepairstore.com or give us a call at 1(336)992-3611. We are here for all your industrial electronic repair needs.
Пікірлер: 5
We are having the same code truck wont shift but no work was done to the trasmission could it still be a glitchy software also u guys updated the cpc or the tcm??
I have same error, can I fix from my side
I Have a code on my dash saying Gear Pos. Sensor Problem Detected Shifts Inhibited 2015 automatic Frieghtliner cascadia Which it’s not allowing me to go into to gear once I go into gear it just Beep I had water in my air tanks I had to drain out It started to work but next day Same thing happened Fault code spn 521485 fmi 2
@erdltd
Жыл бұрын
that is not the cpc4 but more than likely a real shift sensor issue which is connected tot he transmission controller
@eddierad4944
Жыл бұрын
@@erdltd hi I was driving this morning and my dash lites all came on and then off as I was driving but it happened so fast that I am not sure if the truck completely turned off and back on and it happened twice as I was driving today then I arrived at a truck stop and turned it off myself for 30 minutes or so then as I turned it back on it started rite up and still continues to start rite up but the red def lite is flashing and my def is full and also my dash has no communication with voltage or diagnostic and rpm gauge is also not responding and there is no throttle either just idle and the pndb unit is the original unit with red paint