Compression spring design - Force, Rate and Deflection
Basic introduction to spring design. How to work out compression or extension spring rate, force and deflection. Spring free length, minimum working length, maximum working length & solid length. Spring stiffness. Spring calculation, spring load.
Пікірлер: 11
Thanks! Glad to help!
Good one.Thanks
NICE VERY HELPFUL
Nice
Whether the pitch of spring doesn't have any effect on load
@PDWCreative
2 жыл бұрын
If you change the pitch the free length will change. If the loaded length stays the same this will have some effect on stress and force.
Installation length will be 20% of ..... ?? Either free length or something any ??
@PDWCreative
Жыл бұрын
Your working lengths and required force are whatever your design requirement is. You just need to bear in mind the free and solid / shut lengths needs considering as well
F1 = 2.91N , Deflection-1 = 6.56mm ( 2 formulas where conflict). F1 = G x d4 x df1 / 8xD3 x Na , df1 = 8 x F x D3 x Na / d4 x G
Height H, Mass M, spring compression x If Height 2H, mass M, What will be the compression
@PDWCreative
3 жыл бұрын
The compressed length should be at least one of your working lengths. Your spring design revolves around the required force and compressed loaded length. Once you know this you can start working out your spring free length, diameter, coil count and so on.