Ich mag den Bass beim Wechseln der Werkzeuge :D tack, tack tack, booom :)

@rf11423

Жыл бұрын

Ich kann dir sagen dass dir dieses Geräusch und vorallem wie lange die Maschine beim Wechseln braucht sowie die Zeit die die Spindel zum beschleunigen und bremsen braucht mega auf die Eier gehen kann :D

Sehr schönes Video! Vielen dank fürs teilen. Wie hast du die Kamera am Werkzeugrevolver befestigt?

@mygcode-cnc-cad-cam

Жыл бұрын

Hallo, per Magnet. Schöne Grüße

Ist das mit so einer shopturn Steuerung wie von Siemens programmiert worden? Sieht mir danach aus. Klar es geht hierbei nicht um stückzeit aber da kann man gefühlt 5min rausholen ^^

Wann kommt der 2 teil

@mygcode-cnc-cad-cam

2 жыл бұрын

Hi FLber, momentan sind wir an einem Schachbrett dran. Wenn einer der Schüler parallel wieder einen Hammer als Projekt dreht, werde ich natürlich sofort die Kamera auspacken. Das könnte noch was im Juli werden. Schöne Grüße

How much is this cnc

@DraconixDG

Жыл бұрын

Around 200k $

Công đoạn quá mùa mè

Waste of time. Cutting off in 7 steps ? there should be 2, max 3 cuts. If its only 10 parts its doesn`t matter, but if you must make 1000 parts you just losing lot of money.

@djangounchained7841

2 жыл бұрын

What i see is not cutting of in 7 steps. the cutting steal is doing a profile on the back with roughin and finishing the ball and after that the cutting off comes. Tell me when i am wrong.

@rafaz705

2 жыл бұрын

@@djangounchained7841 yeah, you just named this two processes like in book, but for me its two cuts and i can do this in 10 seconds, not like on this video in 45. I can easily do this part in 60-70 sec and double efficiency of machine (and earn double money).

@mygcode-cnc-cad-cam

2 жыл бұрын

@@rafaz705 Hi guys, the last part is indeed not the fastest solution. There are some different reasons for this. First of all, this is the first part our new cnc pupils do after they learned din iso programming on pcs. Because of this cutting speed and feed are not like in production environment. Second reason. The cycle. If you are programming a cutting contour in Heidenhain CNC Pilot 640 the cycle will rough and finish the flat surface (left). This is not necessary and costs time. Look at the image ibb.co/20zTmwL . The red line will also get a finish. To avoid this you can do different things. You can limit the cycle in Z for example. This didn't happen in the video. But guys please don't forget, that many programms are written by our pupil in our school who are doing their first steps in cnc. We all know that there is more possible.

@rf11423

Жыл бұрын

This Machine is no Machine for producing lots of parts. Did you see how long this turret takes tó change tools or the spindle reaches the RPM? Sure you can make this part a lot faster but why should i dot this on a machine like this. When you want to print money then buy a CTX variant.