Watch how to replace a rear brake caliper on a 2011 chrysler 300c awd with #moparbro fred_eazy21
Part # MOPAR 68548611AA
Should be the same process for the chrysler 300 v6, the chrysler 300 srt8 would have brembo brake systems which are different.
Replacing the rear brake caliper on a 2011 Chrysler 300C AWD involves several steps. Below is a step-by-step guide to help you through the process:
Tools and Materials Needed:
Jack and jack stands
Lug wrench
Brake caliper tool or C-clamp
Wrench set - 10mm box wrench, 13mm socket and 18mm socket
Brake fluid
New brake caliper
Brake cleaner
Rags
Torque wrench 1/2" & 3/8"
Brake bleeder kit (optional)
Step-by-Step Guide:
1. Preparation:
Safety First: Ensure the car is on a level surface. Put on safety glasses and gloves.
Loosen Lug Nuts: Before lifting the car, loosen the lug nuts on the rear wheels slightly using a lug wrench.
2. Lift the Vehicle:
Jack Up the Car: Use a jack to lift the rear of the car and place jack stands under the car for safety.
Remove the Wheel: Fully remove the lug nuts and take off the wheel.
3. Remove the Old Caliper:
Locate the Caliper: Find the rear brake caliper. It will be over the rotor.
Disconnect Brake Line: Use a wrench to loosen the brake line fitting. Have a container ready to catch any leaking brake fluid.
Remove Caliper Bolts: Remove the bolts that secure the caliper to the bracket using the appropriate wrench or socket.
Remove the Caliper: Carefully slide the caliper off the rotor. Be cautious with the brake line still attached.
4. Prepare for the New Caliper:
Inspect Components: Check the brake pads and rotor for wear. Replace if necessary.
Clean Mounting Area: Use brake cleaner to clean the area where the new caliper will be installed.
5. Install the New Caliper:
Position the New Caliper: Place the new caliper over the rotor.
Reattach the Brake Line: Connect the brake line to the new caliper and tighten it securely.
Secure the Caliper: Install the bolts that hold the caliper in place and tighten them to the manufacturer’s specified torque.
6. Bleed the Brakes:
Check Brake Fluid Level: Ensure the brake fluid reservoir is full.
Bleed the Brakes: Open the bleeder valve on the new caliper and have an assistant press the brake pedal to remove any air from the system. Close the valve once the air is expelled. Repeat this process until no air bubbles are seen.
Top Off Brake Fluid: Ensure the brake fluid level is topped off after bleeding the brakes.
7. Reassemble:
Reinstall the Wheel: Place the wheel back on and hand-tighten the lug nuts.
Lower the Car: Carefully lower the car off the jack stands and onto the ground.
Tighten Lug Nuts: Use a torque wrench to tighten the lug nuts to the manufacturer’s specifications.
8. Final Checks:
Test the Brakes: Before driving, press the brake pedal several times to ensure it feels firm and check for any leaks around the new caliper.
Road Test: Take the car for a short drive to ensure the brakes are working properly.
Tips:
Always replace brake components in pairs (both rear calipers) to maintain balanced braking.
Dispose of used brake fluid properly.
Check the vehicle’s manual for specific torque settings and brake fluid type.
By following these steps, you can successfully replace the rear brake caliper on your 2011 Chrysler 300C AWD. If you’re not confident in your mechanical skills, it’s always a good idea to seek help from a professional mechanic.
For more #Mopar & #chrysler content please subscribe!