Thanks for being the only one to say the valve cover torque specs anywhere!!!

Thanks for the lessons...

Thank You So Much for this video. I was stuck trying to get the bolts through the grommets. I was ready to put the plastic spacers in upside down to make it work. You're a life saver. 2005 Chevy Impala.

I'm working on a blown head gasket on my daughters 01 Malibu and your videos have been super helpful. 👍🏻

i will second the dielectric silicone grease on the o rings. 30 years ago i was taught to use it on ac system snap lock o rings to eliminate come backs for ac work. when i used it ever time i never had another leaky coupling especially early hyundi or however that is spelled and some fords. so i started using on every o ring i touch. it has never caused me a problem and i am sure it has saved hundreds of hours in rework for free..........

Thank you😄

@ProblemSolverGarage

2 жыл бұрын

No problem thanks for watching

Do I have to TDC each valve per cylinder to relieve tension on rocker arm spring to tighten the push rods and rocker arms each cylinder?

Do you have the video where took off the top? I have a 2003 and there are few things I have to move and I'm not sure how to do that. Also, when you take one of the forks off, should you have a jack to support the engine?

I have a 1998 Chevy Venture LS 3.4 that has unfounded oil consumption. Will this video apply as it is from 2001 - 2004 Ventures. Thanks

@ProblemSolverGarage

Жыл бұрын

I believe it’s the same

@poppysnoop9425

Жыл бұрын

@@ProblemSolverGarage Thanks for the info

You showed how to replace the fuel injectors but but the O-rings on them you never gave the torque specification on the upper intake manifold

where u from? i’m getting eastern european vibes? am i right?

@ProblemSolverGarage

Жыл бұрын

Actually I’m at the end of the world in northern Canada 🇨🇦