Perfect video. Exactly what I was looking for. Thank you for the info

Would overfilling a transmission cause the seal to leak?

Thanks for the tips

I have a 2000 explorer. It slips with RMP raising and change at times. It has a good take off and 1 to 2. the engine code is po720 which I changed. what else could I check or could I try Lucas transmission?

Getting ready to replace the front shaft, or torque converter seal on my 96 Camry V6, what brand of seal do you recommend I get, it's the A 541 E transmission, any info would be appreciated

Me have toyota tundra problem is after hot canvartar seal coming out 3time the problem. What is tha reason

Awesomeness

Great advice. Thanks

I am troubleshooting a front seal leak problem on a aisin 6F21WA after engine rebuild. this video addresses EXACTLY my problem. I am not sure I missed the dowel pins, or the pump bushing itself has worn after 160k miles that the neck of the tc is no longer CONCENTRIC (after loosening and retightening of the 6 tc bolts) to the seal, therefore rubbing it, and leaks at high engine rpm. Any easy way to replace that pump bushing without taking that pump out?

Yes sir all this info. helps us out alot. Thanks.

I have a transmission leak between the engine and transmission on a 2015 dodge crew caravan. i got a new oil pump installed however it still leaks from that area. Could it be the torque converter? because when accelerating the vehicle, more oil comes out faster

@codemansauto208

8 ай бұрын

yes it could be the converter or it could be a seal

How much is the cost of the repair?

Took my 3rd gen dodge 3500 with the Aisen in for a motor swap, had a trans fluid leak i couldn’t pin down until eventually I ended up with a hole in bell housing….. took back they refused tho honor my warrantee. I’ve had the trucks backs for a couple months now and I’ve noticed the same thing happening again…. The dipstick had broke last time and the guy replaced it with the wrong dipstick, it’s not registering any fluid at all but my edge monitor should trans temp staying under 150 most of the time (unloaded)…. Is this my issue?

@codemansauto208

4 ай бұрын

if you replaced the Engine and didn't put both dial pins in, then this can cause your front seal to leak because it wears the bushing on the front of the converter. we have a video that explains this, just a thought Hope this helps you

I have a 4r100 in a 99 f250 with a v10 and the torque converter seal leaks only whe the truck is in reverse do you know what problem I might have

@HeightSupremacist

25 күн бұрын

I have the same problem in my 2004 F250 4 x 4 5.4 L, engine was replaced by a shade tree mechanic eight or nine months ago, he replaced the torque converter seal at that time, my suspicion he left out one or both of those pins 😮

Nice! Thanks

What happens if I fill only 6 quarts (school bus requires 17 quarts), and go D, R twice for 6.5ft ? Does that make front pump seal (or bush) burns out and starts leaking fluid a few weeks later ?

@codemansauto208

Жыл бұрын

No, if you ran it for a long period of time with only 6 quarts of fluid it could have gotten the seal hot but I do not think that this caused your issue.

Automatic transmission fluid leaks when its on reverse gear ( toyota camery 2.4 )

I have a leak right between the engine and transmission. Im guessing its the seal because its the original trans, no swap

@codemansauto208

Жыл бұрын

sounds like it

@BUCK4NIER

Жыл бұрын

What is that seal called on a C6 transmission?

I installed a new transmission and as we where bolting it down there was a load pop noise and it started dumping oil out the bell housing be hind the flywheel

@NeoJSsk

2 жыл бұрын

Right now mine is doping oil as I put it in it goes out trough the bell housing where the bell housing cover goes, (Manual transmission)

@aneesjames5373

10 ай бұрын

​😮 0:15

@arifulmahalot743

9 ай бұрын

@@NeoJSsk ।।

@arifulmahalot743

9 ай бұрын

@@NeoJSsk লন

@rogerthat6221

6 ай бұрын

It’s a wrap. You broke the front pump

Name video dial pin.