Cheap Chinese X Y table fitting up the upper deck After fitting and fettling and forni... around.

Ғылым және технология

So in this video I go over what I did to get the slop out of the upper deck. It turned out to be several little things. There is still some lapping in to be done, but I am actually surprised as to how good the fit has become.

Пікірлер: 4

  • @lesblack413
    @lesblack4139 ай бұрын

    I am a Mechanical Engineer with many years of experience. I probably would have used bearing blue to show the high spots first, then adjusted the surface with a hand scraper. Fit the top slide and tighten up the gibb key, check there is sufficient blue on the slide and repeat the process. This is the process for lathe bed truing. Cheers from Australia.

  • @oldfarthacks

    @oldfarthacks

    9 ай бұрын

    Thanks for the advice. I had in a sense done that by filing a bit before the lapping process. The same with the gibs, filed them and then lapped. I also did not care about removing too much material, which is why you do the scraping process. These surfaces are more or less delivered oversize.

  • @PeckhamHall
    @PeckhamHall10 ай бұрын

    It's just not big enough to be much cop, but the compound idea I was going to say last time, so i agree. The gib drill and tap centre hole and shim just under that area and twist the 2 ends. You can always twist them back.

  • @oldfarthacks

    @oldfarthacks

    10 ай бұрын

    Thanks for the ideas.

Келесі