he did everything alright, but he should recalibrate the steering sensor by inpa or dis. u can find it in inpa in dxc8 module or something like this i dont remember. ITS A ASNWER FOR OLDER COMMENTS.

Thanks to you, iv’e done mine..thank you again for your video

You can use DIS to calibrate the sensor

How do you take the panel off under the steering wheel?

Not so easy actually which way up do the new one gos in with writing towards the steering wheel or the other way ? Also you need to make sure your steering wheel is positioned properly before putting it back together 😢

Selflevel sups inact ?????

If you change out the sensor for a new one, you will need to have the new one coded for your vehicle, otherwise you'll still get the same warning lights on the dash.

@animusmartini5727

2 жыл бұрын

If the Sensor is new,you only need to calibrate it with Rheingold

@TheDoctorBoy

2 жыл бұрын

@@animusmartini5727 what if the sensor is used? How should we code it?

Self level susp inact???

Hi, I've heard that if you're getting constant 4x4 light, you should try to calibrate the steering angle sensor, not change it. Do you know how to do that? What is meant by recalibration and how to do it. Thanks

@emin3nt46

4 жыл бұрын

I dont know how to do that

@leeroyhustle

2 жыл бұрын

Suspend the car completely off the ground. Then turn the steering to the left until it locks. Do so for the right . It should clear

Did you resolved your 4x4 light?

@emin3nt46

5 жыл бұрын

No mate. I changed the sensor but the light is still there

@jamesstclair9571

5 жыл бұрын

Problems in the Transfer Case

@stevenjames7073

4 жыл бұрын

@@emin3nt46 u need to recalibrate the new angle sensor and it can be done using a scan tool...I did it too many times ..its very easy

@eugenemelbourne4540

2 жыл бұрын

Dis? 1

I didn't think 4x4 light had anything at all to do with steering angle sensor tbh. Will be transfer box gear motor/ sensor

@emin3nt46

5 жыл бұрын

I still dont know whats wrong

@laurieh

5 жыл бұрын

@@emin3nt46 plastic cogs in transfer box motor wear...

@Ramps_818

4 жыл бұрын

emin3nt have you fixed it? Mine is the same and apparently my sensor is faulty, the light is on because the vehicle stability control is not working because it isn’t getting a steering angle signal.

@svetlo17

2 жыл бұрын

I am getting a code for the steering wheel sensor which is causing my 4x4 light to be on. So check what code you r getting

@newgeneration9524

Жыл бұрын

There is a lot you don't know