In this tutorial, you will learn about the Cascade control strategy. The setpoint from the primary (master) controller is used to drive the secondary controller. Also, we will see how to configure cascade control across the shell and tube heat exchanger to see the dynamic behavior of the process variable.
📢 If you find my content helpful, please don't forget to subscribe to my channel bit.ly/3b6wuV9 🔔.
If you want ❤️ to learn Aspen HYSYS from very basic, then check the following links:
Tutorial # 1
Getting started with Aspen HYSYS
• Getting started with A...
Tutorial # 2
Bubble point, Dew point and Phase diagram calculations
• Bubble Point, Dew Poin...
Tutorial # 3
Flash calculations in HYSYS
• Flash Calculations in ...
Tutorial # 4
Sensible and latent heat and generation of saturated steam table in Aspen HYSYS
• Sensible and latent he...
Tutorial # 5
Centrifugal pump sizing and selection in six easy steps
• Centrifugal pump sizin...
Tutorial # 6
Pump power and efficiency calculations in HYSYS
• Pump power and efficie...
Tutorial # 7
Pump performance curves generation and rating in HYSYS
• Pump performance curve...
Tutorial # 8
Simulation of Compressor and Turbine in Aspen HYSYS
• Simulation of Compress...
Tutorial # 9
Compressor Surge Analysis in Aspen HYSYS
• Compressor Surge Analy...
Tutorial # 10
Pipe Sizing, Pressure Drop Calculation, Use of Adjust Function in HYSYS
• Pipe Sizing, Pressure ...
Tutorial # 11
How to use case study tool and generate vapor pressure curve for Propane in HYSYS.
• How to use case study ...
Tutorial # 12
Crude oil three-phase separation | Decanter simulation in HYSYS
• Crude oil three phase ...
#Cascade #DynamicSimulations #HeatExchanger