Carrier APU Not Running? Tips On How To Diagnose It
Жүктеу.....
Пікірлер: 14
@CVForseti Жыл бұрын
Good video Tim. Very informative, and these are the type of videos drivers out there look for. Good job.
@macho16572 ай бұрын
SUPER THANK YOU.....
@dwayned6629 Жыл бұрын
Good video Tim
@shawnfairman911 Жыл бұрын
Good tip
@vjm62389 күн бұрын
Hi thank you for your video. I have SOL HOLD andALT POWER light and I had fault engine overheating and it shut off unit couple of times but it starts and runs and stops after some time. Maybe you had experience with issues like this. Thank you. Vj.
@Truckingwithcooper45
9 күн бұрын
@@vjm6238 check the oil level and make sure it’s at the correct level. Also look for antifreeze pooling on the ground under the APU. Could be a bad water pump causing the overheating problem.
@PoptartGoneTrucking7016 Жыл бұрын
Put a rock on the fuel pedal and idle the truck
@joseramirez2459 ай бұрын
How would you go about bleeding the fuel line?
@Truckingwithcooper45
9 ай бұрын
Need to crack open the nut running into the top of the injector and crank the motor. As your doing that watch for air coming out. Do this until it’s noting but a solid stream of fuel. Then retighten the nut.
@stevenwilson9678 Жыл бұрын
U should make a video on how to do orientation since ur a orientation specialist
Пікірлер: 14
Good video Tim. Very informative, and these are the type of videos drivers out there look for. Good job.
SUPER THANK YOU.....
Good video Tim
Good tip
Hi thank you for your video. I have SOL HOLD andALT POWER light and I had fault engine overheating and it shut off unit couple of times but it starts and runs and stops after some time. Maybe you had experience with issues like this. Thank you. Vj.
@Truckingwithcooper45
9 күн бұрын
@@vjm6238 check the oil level and make sure it’s at the correct level. Also look for antifreeze pooling on the ground under the APU. Could be a bad water pump causing the overheating problem.
Put a rock on the fuel pedal and idle the truck
How would you go about bleeding the fuel line?
@Truckingwithcooper45
9 ай бұрын
Need to crack open the nut running into the top of the injector and crank the motor. As your doing that watch for air coming out. Do this until it’s noting but a solid stream of fuel. Then retighten the nut.
U should make a video on how to do orientation since ur a orientation specialist
@Truckingwithcooper45
Жыл бұрын
Maybe I should
What about no fuel pressure
@Truckingwithcooper45
Жыл бұрын
That would indicate a failed fuel pump.