You can use the choke lever to plug the gas line.

Great explanation. I just installed carburetor at my Honda power washer GX 200 6.5 following your instructions. It was very helpful. I have to get a gas and will tell you how it goes. Thanks, Jasbir Mongia

thank you! someone just gave me one of these pressure washers. trying to start a side hustle. hopefully this gets it working again.

I put a new Honda OEM carb on my gx 200. It would start but not stay running. I watched your video and the manifold gasket, I put on backwards. Hole twords the valve cover. I reversed it and it runs like a scalded ass cat. You saved the day. Thanks 😊

Thanks for the video Currently trying to get an old pump to run with a 120 engine attached that my neighbour was just going to throw away

Video was very helpful to be sure the procedure to remove and replace the carb properly including installing the governor linkage and gaskets. You can use the male part of the plastic choke to plug the fuel line while working on the carb. In my case the fuel tank needed to be replaced due to hard varnish and rust.

Golf ball tee to plug the fuel line. Great video, Thanks !

Thanks for sharing that. It's a detailed and helpful video with helpful tips.

Super helpful, thanks for doing this!

Super helpful video. Appreciate it.

Can you show me how to build my own racing mower

Definitely was helpful video as someone who doesn't know anything about small engine or any engine for that matter. Definitely was good video. I myself thought About using a wood pallet sometime goof around and turn one into a go kart basically making a wooden go kart.

So do the Honda GX200 and GX160 have the exact same carburator?

Very well done.

I took the gas tank completely off. There was a cheap wire hose clamp that I just twisted off with a pair of pliers because I'm replacing it with a better hose clamp anyway and the damn thing actually sparked when I broke it off. Nothing ignited but damn.

Great job

If you use the choke lever round rod to plug the gas

There is a niple on the choke lever and it will fit in the fuel line

I installed the carb, but if I open the choke at all it revs up a ton. What am I doing wrong?

You know the air box will still go on and off if you fully close the choke and turn off the gas right? And also you can reuse the gaskets if they aren’t ripped to shreds.

@Fucknuts4u

11 ай бұрын

wow thanks for that time saving tip...

Just did this on a 140. I ordered a carb from Honda and replaced everything around it.

😂 tells everyone first thing you want to do is drain the gas, yet literally holds his finger over the gas line for the entire swap 🤷‍♂️ 🤦do as I say not as I do? That engine is a keeper , cleans off a saw table work bench real good! 👍😆 … ✌️🤙

You forgot 1 thing, you did not put the hoseclamp back on the fuel hose.

Clamp fuel line

That filter looks healthy, NOT!