No video

Can This Clutch Cable Improve Your Ride? - Harley Davidson 2023 Road Glide Special

Today at the shop we're investigating the Barnett High Efficiency one Piece Clutch Cable on our 2023 Road Glide Special R&D bike: GoldenRod!
JD's Cycle Works is located at 6146 Sullivan Trail, Nazareth PA, 18064.

Пікірлер: 8

  • @markmcintosh7095
    @markmcintosh7095Ай бұрын

    Thanks, that is great information.

  • @fredgemigniani589
    @fredgemigniani589Ай бұрын

    After putting the new clutch cable on, I noticed that your handlebars were turned to the left. When on the Test before your handlebars were straight. I think that will make a difference on your test.

  • @lancasterjim2441
    @lancasterjim2441Ай бұрын

    We like to just avoid any increase in lever pull by using the Barnett extra plate kit instead of using springs.

  • @lancmac
    @lancmacАй бұрын

    I have a 23 CVO 121CCV roadglide and The muller/Advanblack/Prizoma ramp will give a clear .080+ clearance with about 14.5# pull. Shifts like better... Be aware you have to exactly 1/8 turn clearance on the clutch adjusting screw.. Not the 1/2 to 1 turn HD adjustment with stock springs

  • @daveb8457
    @daveb8457Ай бұрын

    Man David that is some good info right there. Thanks for making this video.

  • @midas61
    @midas61Ай бұрын

    Should have used a small kitchen scale to push on the lever until it contacted the bars.

  • @BlancoFlaco
    @BlancoFlacoАй бұрын

    Very informative ty

  • @geraldgoodiii6993
    @geraldgoodiii6993Ай бұрын

    Do u know what the spec is for a AIM SDR? I had to set it at barely a 1/2 turn (if I do like 3/4 turn I’ll get stuck in gear at anything over like 4500 rpm) and minimum acceptable free play at WOT (gotta leave it tad looser at idle bc as that shit spins up the little fingers go in and snug up the lever .. of set “properly” at idle .. that clutch cable is TIGHT at 5k rpm

Келесі