Bosch GCM 8 SJL Never measure up against the saw blade Make an adjustable measuring block Machine in the video Bosch GCM 8 SJL www.harrisknudsen.dk
Жүктеу.....
Пікірлер: 14
@karl-davidhjalmarsson10502 жыл бұрын
Elegantly explained! Thank you very much!
@Harris-DIY
2 жыл бұрын
Thank you for your comment
@vjachaslavbur88023 жыл бұрын
Интересное видео!
@Harris-DIY
3 жыл бұрын
Vjachaslav Bur Thank you for your comment
@JohnColgan.3 жыл бұрын
Hmm, you have a visible blade deflection there on pressing sideways, lots of hinges & swivels to overcome. Though I would have thought the difference between the blade width & TCT kerf cut. You appear to have made a single sided kerfing jig to account for the TCT teeth
@Harris-DIY
3 жыл бұрын
John Colgan Yes, it's really only a half kerfmaker
@david-un3om3 жыл бұрын
How to set this saw for perfect 45 angles for picture framing. Seems to be all over the place.
@Harris-DIY
3 жыл бұрын
david mezzone Try watching this video kzread.info/dash/bejne/mHuluLeSiMmWlJc.html
@MuyBienFelipe3 жыл бұрын
How did you measure the distance at which to position the screw on your jig?
@Harris-DIY
3 жыл бұрын
You screw the screw into the block until it is flush with the left side of the saw blade and make a few test cuts where you fine-tune with the screwdriver until it is completely accurate
@Tinker19503 жыл бұрын
The sound level in your videos needs boosting.
@Harris-DIY
3 жыл бұрын
John Walker It's stormy here, so all that's missing is the wind and my neighbor making noise with a machine :-)
Пікірлер: 14
Elegantly explained! Thank you very much!
@Harris-DIY
2 жыл бұрын
Thank you for your comment
Интересное видео!
@Harris-DIY
3 жыл бұрын
Vjachaslav Bur Thank you for your comment
Hmm, you have a visible blade deflection there on pressing sideways, lots of hinges & swivels to overcome. Though I would have thought the difference between the blade width & TCT kerf cut. You appear to have made a single sided kerfing jig to account for the TCT teeth
@Harris-DIY
3 жыл бұрын
John Colgan Yes, it's really only a half kerfmaker
How to set this saw for perfect 45 angles for picture framing. Seems to be all over the place.
@Harris-DIY
3 жыл бұрын
david mezzone Try watching this video kzread.info/dash/bejne/mHuluLeSiMmWlJc.html
How did you measure the distance at which to position the screw on your jig?
@Harris-DIY
3 жыл бұрын
You screw the screw into the block until it is flush with the left side of the saw blade and make a few test cuts where you fine-tune with the screwdriver until it is completely accurate
The sound level in your videos needs boosting.
@Harris-DIY
3 жыл бұрын
John Walker It's stormy here, so all that's missing is the wind and my neighbor making noise with a machine :-)