BMW Airhead Rear End Oil Leak!
Автокөліктер мен көлік құралдары
Thanks for watching, the Driveshaft holds 150CC of gear oil, don't forget to top it off after reassembly.
REAR DRIVE BOOT- bmwpartsguy.com/products/swin...
REAR DRIVE BOOT CLAMPS- bmwpartsguy.com/products/swin...
Join this channel to get access to perks:
/ @thebmwguy
Пікірлер: 21
I happen to own that Bike in the video and was able to get out on a ride for the first time since purchasing it 3 weeks ago. Man does it ride sweet. The carb work that was also done has it running tip top. Tic over is consistent and strong and fueling is great through mid range and high revs. Nice work on this video you make it look easy and explain the job well.
@TheBMWGuy
Жыл бұрын
Glad everything works well! Also thanks for joining my channel.
Oben means up; Unten is down. So you are right. Greetings from Germany, Berlin. Berlin the home of BMW Motorrad. 😊
you don't have to remove the final drive from the swing arm . i even leave the wheel on and still able to remove the whole assembly without problem .
Regarding the swing arm, you should be holding the preload pin in place as you tighten the outer nut. Cut a "window" into the side of the socket so you can fit the Allen wrench inside it while tightening.
@TheBMWGuy
8 ай бұрын
the inner stud wont spin, no need to hold it.
@barrybirkey3282
6 ай бұрын
.@TheBMWGuy You did a lot of unnecessary work to replace the boot. Final drive does not need to be removed. Simply move the swing arm back a bit, remove the driveshaft bolts, replace boot and put back together.
I thought it was the transmission oil that leaked through the output shaft oil seal
@Mtthwpez
Жыл бұрын
Yeah, where was the oil leaking from? It shouldn't have any oil in the drive shaft area, so it's either a faulty gearbox output seal, or a faulty final drive oil seal. In either case, it's not a simple clean up job to fix...
@TheBMWGuy
Жыл бұрын
these old airheads have driveshaft oil.
are you suggesting its the boot which is causing the leak? seems to me its the gear box seal leaking the one that the boot is supposed to be protecting.or am I mistook? Apologies if I am
HI, I have two questions, how to restore and calibrate the carburetors on a 87 bmw r65. And how to replace and install the cylinders and pistons of the same bike. Thank you
@TheBMWGuy
11 ай бұрын
i did a video on the 32mm carb rebuild procedure as well as top end reseal on a r75, both those videos should help you out! if you need more help please e-mail me
Do you not have to grease splines or add any final drive oil on these?
@TheBMWGuy
Жыл бұрын
there is oil in the driveshaft, i will be doing a separate video on this
What year is this bmw you worked on? Dont you need a Swing Arm Gasket for your model or the vedio didn’t capture it?
@TheBMWGuy
8 ай бұрын
1972, no gasket. just RTV
A BMW leaking oil !?!? No way !!!
@TheBMWGuy
Жыл бұрын
crazy!!
There are easier ways to do this job. Pulling the tire and final drive aren't part of them.
'PromoSM'