Big Mistakes in RCC Slab - Lapping Mistakes - Reinforcement Mistakes - Civil Engineering
Жүктеу.....
Пікірлер: 12
@abdulmotin89022 ай бұрын
Standards rod good good good work thank you
@hawsaromerhama725 Жыл бұрын
90 degree bent is allowed but in the case of designing building for seismic zone it should bent by 135 degree for stirrups and ties , because it is not easy to use 135 for all buildings
@lameckorido8224 Жыл бұрын
Good explanation 👍
@mikeweatherford1224 Жыл бұрын
In a continuous slab when using crank bars in each slab panels at each and every beam intersection is it acceptable to provide the lapping with the cranked steel over the top beams at a distance of L4 on each side of beams ? If no where is the proper lapping zone when cranked steel bars are used in slab panels at each and every beam intersection ? Thank you Sir
@mfutobongemmanuel483811 ай бұрын
I cannot see top distribution bar along the beans why?
@abdulmotin89022 ай бұрын
Nice nice, have dalai
@arbabkhan80268 ай бұрын
Thanks sir
@ahmedzohair9905 Жыл бұрын
Is it not necessary to provide one way or two way slab ? Here I can see only straight bars and no crank bars and Extra bars.
@ahmedzohair9905
Жыл бұрын
Pls clarify. Weather can we skip crank bars and extra bars
@MrMallick736 Жыл бұрын
Lapping depend on distance
@ShuaCigar Жыл бұрын
Lapping location of slab bottom bar must be on beam..but lapping of slab top bar shouldnt be at beam
Пікірлер: 12
Standards rod good good good work thank you
90 degree bent is allowed but in the case of designing building for seismic zone it should bent by 135 degree for stirrups and ties , because it is not easy to use 135 for all buildings
Good explanation 👍
In a continuous slab when using crank bars in each slab panels at each and every beam intersection is it acceptable to provide the lapping with the cranked steel over the top beams at a distance of L4 on each side of beams ? If no where is the proper lapping zone when cranked steel bars are used in slab panels at each and every beam intersection ? Thank you Sir
I cannot see top distribution bar along the beans why?
Nice nice, have dalai
Thanks sir
Is it not necessary to provide one way or two way slab ? Here I can see only straight bars and no crank bars and Extra bars.
@ahmedzohair9905
Жыл бұрын
Pls clarify. Weather can we skip crank bars and extra bars
Lapping depend on distance
Lapping location of slab bottom bar must be on beam..but lapping of slab top bar shouldnt be at beam
dear main bar end the beam