Awesome, Gal! Fantastic flying and review! 😃 Pretty nice little quad! Love it! Stay safe there with your family! 🖖😊

@KremerFPV

7 ай бұрын

Thanks Mario!

thank you, I ordered it for myself in Poland

@KremerFPV

6 ай бұрын

Enjoy it!

Hey dude nice video ,i just bought one pavo20 im curious about the range , i just bought that cames with erls receiver,do you know about the range of it ? Tks foor all

Hi. Awesome video. Which mode was used to assigned the COB led strip? I can see”LowLED”, but that one controls the motherboard LED. Thanks!

@KremerFPV

4 ай бұрын

Thanks. User 1 mode.

Great review

@KremerFPV

7 ай бұрын

Thank you!

Hello, I bought a Pavo 20. Before installing O3, I was flying with 2-cell and 3-cell batteries without any problem. But after installing O3, it does not fly at all with 2-cell batteries, and with 3-cell batteries, it flies at 90% throttle and with difficulty. where is the problem from ? I have a 2 cell battery : tattu 450mah 75c and a 3 cell battery : boslipo 650mah 95c

Nice review, but i have a question... if i buy it with o3 airunit and elrs receiver... can i control it with my rm zorro elrs or with my dji fpv remote 2 ??? I have both radios but i was curious if i can switch my radios if i need/want it. Thanks in advance!

@KremerFPV

6 ай бұрын

Thank you. Sorry for the late response. Yes, you can switch between the two - but you will need to modify BF settings each time (set the RX to the desired UART port).

@ghuva

6 ай бұрын

@@KremerFPV I had the same question, I am a beginner in this FPV world, do you have any tutorial to make this change in BF? thank you😆

very bright camera!

@KremerFPV

6 ай бұрын

😃

thanks for the comparison

@KremerFPV

7 ай бұрын

No problem!

Is the frame decent? I am thinking of buying it to put my Cetus X inside, the frame it has now isn’t the best and overheats so I was wanted to put it in a more open one… if the frame shatters easily I won’t get it but if it is good then yea it sounds wonderful… the design is just cool

@KremerFPV

7 ай бұрын

I haven't crashed it but it looks quite decent (better than the Pavo Pico).

What kind of flight time are you getting on it....? And can you run Gyroflow on the footage you get from the dji 03 unit...?

@KremerFPV

6 ай бұрын

About 4 minutes, but it can do better using bigger batteries. Yes you can use Gyroflow - make sure that Rocksteady is turned off and then you will be able to use the O3 Air Unit GYRO CSV data.

Hello, good video, but I can't connect the DJI Radio V2 to the Pavo 20,I can connect everything to the DJI Air Unit 03 to the DJI V2 radio and the glasses but the drone doesn't work,How can I connect the DJI V2 radio to the Pavo20elrs? Thank you

@indroneswetrust1

2 ай бұрын

I think you might have to do 3 times the lipo plug in your drone 3 times then the 3rd time, you leave it plug in, that's how the ELRS works and it will bind successfully to your radio controller. What kind of your radio controller?

Hello! Would I be able to install a new ELRS receiver on the TBS version? Do I have enough uarts?

@KremerFPV

2 ай бұрын

Hi, sure. You can use the same UART the CRSF receiver was connected to.

I have one more question, can I add GPS and a buzzer? Is there room for these additions?

@KremerFPV

6 ай бұрын

Yes, you have enough UARTS. Go for a nano GPS unit and you should be ok 👍

Which one do you suggest for beginners, the Pavo Pico or the Pavo20?

@KremerFPV

7 ай бұрын

I would go with the Pavo20 - better camera protection and you can use 2s batteries as a start and move to 3s batteries as you advance.

Is this pavo20 the same size of mobula 8, right? 2inch props, but 3s battery are worth for those who have the mob8?

@KremerFPV

7 ай бұрын

If you already have the Mob8 I'm not sure if I would get another 2s/3s whoop - especially if you're happy with it.

Can you please show a video on how to bind it I tried to bind it and simply can’t please help I have the elrs version

@KremerFPV

7 ай бұрын

Easiest option is to use a bonf phrase. Do you still need help with this issue?

Hi, thk you for this video. Do you have a tuto to configure the led trip on an auxilary, i failed it :( thank you bye. Romain.

@KremerFPV

6 ай бұрын

My pleasure. Just assign the USER1 mode (Betaflight Flight modes tab) to an auxiliary channel on your radio controller.

Hi, My pico was working fine until now. I just updated the firmware via Betaflight and now when i raise throttle my quad flips and acts funny. After firmware upgrade do i also need to update the firmware of the esc? I have the pavo pico version 2.

@KremerFPV

7 ай бұрын

Hi, you need to update the Betaflight settings. You can find the dump settings in the video description.

Hi! Can you install the Walksnail HD Pro system?

@KremerFPV

6 ай бұрын

Hi, yes :-)

Can I use any Goggles with the pavo20 with dji03? ❤

@KremerFPV

3 ай бұрын

No, DJI Goggles v2/2

How did you get rid of the prop guards in the fov?

@KremerFPV

3 ай бұрын

I don't remember doing anything special.

Пушка маленькая 😂

@KremerFPV

7 ай бұрын

Which gun?

what do you prefere pavo 20 o3 or mobula 8 o3

@KremerFPV

5 ай бұрын

I think that the Pavo20 is more agile and fun to fly (on 3s batteries).

😍😍😍💣💣💣

@KremerFPV

6 ай бұрын

🤟

First hahaha

@KremerFPV

7 ай бұрын

🍺

Very good looking drone , but I will never buy anything from betafpv after my pavo pico aio dies in 2 months

@KremerFPV

7 ай бұрын

Sorry to hear about that...

@damianwyczakowski2491

7 ай бұрын

@@KremerFPV but maybe this drone will be better... maybe someday I will try this drone

@KremerFPV

7 ай бұрын

@@damianwyczakowski2491 maybe BetaFPV can give you some discount to compensate you. Talk to their customer support team.

Hello, I bought a Pavo 20. Before installing O3, I was flying with 2-cell and 3-cell batteries without any problem. But after installing O3, it does not fly at all with 2-cell batteries, and with 3-cell batteries, it flies at 90% throttle and with difficulty. where is the problem from ? I have a 2 cell battery : tattu 450mah 75c and a 3 cell battery : boslipo 650mah 95c