I have had some experience of those Chinese single cylinder diesel engines, and I would recommend that to reduce the likely hood of balance shaft bearing failure you replace the factory fitted caged bearings with high quality maximum fill bearings. There are two balance shafts with a bearing at each end and the factory fitted caged bearings are prone to failure with catastrophic results.

@DieseloveMotoryDOTsk

7 ай бұрын

Thank you very much for your comment. This particular engine is an SD model and only has 1 balancing shaft. I agree to replace the bearings. Otherwise these are very good engines. Do you have a youtube channel with engines?

@jasonmixon6818

6 ай бұрын

Where do I purchase an engine/ generator set up like this. I’m currently running duetz and how would you compare durability between these 2 engines

That really looks nice!

@DieseloveMotoryDOTsk

9 ай бұрын

Thank you very much! 🙂

GOOD video nice video Engine

Beautiful!

i had a giggle at the "high quality" explosion sticker.

Kompletní Čína. Akorát pár kusů železa je ze Slovenska...😆

what is the maximum kw of the alternator? would love to see maximum load and distortion noise waveform

KEEP SPARE VOLTAGE REGULATOR FOR ALTERNATOR STARTER CIRCUIT AND GENERATOR VOLTAGE REGULATOR IN A FARADAY CAGE FOR EMP AND CME PROTECTION...SPARE BELT IN CELOPHANE AS THEY AGE AND CRACK OVER TIME. SAME FOR HOSES AND FILTERS. YOU MAY NEED SEVERAL FILTERS IN AN EMERGENCY BECAUSE FUEL WHEN AVAILABLE MAY BE CONTAMINATED. A FUEL AND WATER SEPARATOR WOULD BE HELPFUL.

Where can you buy synchronous motors? I can only find induction ones

What size generator do you have and what size pulley on the generator. I have a brand new jiangdong zh1115 diesel engine and a brand new Onan 15kw generator that I am getting ready to build a frame for. Would you be willing to share any information. I have had the engine for 5 years and just purchased the generator. I will be mounting it to I-beams for the frame. My name is Otis

Szép munka!

@DieseloveMotoryDOTsk

Жыл бұрын

Thank you!

Great build. I am planning to do the same. I have a 10HP Kubota and a 15 HP Changzhou. How much Diesel are you using per hour?

@DieseloveMotoryDOTsk

Жыл бұрын

Thank you :) The consumption depends on the load but is usually from 0.5-2l per hour.

Good job, l have 24 HP engine, what is the recommended pulller size for engine and generator using belt system

@DieseloveMotoryDOTsk

3 күн бұрын

Thank you! It depends on the gear ratio. If your alternator has a 150mm pulley and you want your generator to run at 1500rpm, then your engine will reach 1500rpm, if its pulley is also 150mm.

That really is pretty.

@coreybrenner9503

Жыл бұрын

Are the ball valves so you can use the unit as a cogeneration heat source?

@DieseloveMotoryDOTsk

Жыл бұрын

Thank you Corey! 🙂

That thermostat switch can carry the load of the cooling fan motor? I bet not for very long. Most people use a relay in between. Just a suggestion.

Very good🎉

@DieseloveMotoryDOTsk

10 ай бұрын

Thanks 😊

It's so ugly that I'm in LOVE WITH IT.

@DieseloveMotoryDOTsk

Жыл бұрын

Thank you, me too! 😀

Beautiful job, I like your custom alternator mount. Everything looks well engineered, I was happy you showed the electric radiator fan come on. Nice layout too, your engine fit perfectly on the frame. I do like the belt drive, I'd thought about direct coupling but you can get exactly the right RPM for both the pump and the engine. Are the wheels cast iron?

@DieseloveMotoryDOTsk

Жыл бұрын

Thank you for your nice comment! I love the genset too, it's my most favorite out of all we've built. Next time we'll build a direct drive. I hope you stay tuned 😊

How much is the AC head?

Nice build. What's the average fuel consumption at 3500 to 4500 watts?

@DieseloveMotoryDOTsk

Жыл бұрын

Hi, is about 1l per hour

Single cylinder disel engine can use AVR system with dynamo. How to do adjust Rpm of engine and dynamo voltage??? May I know about it. Thank you.

@DieseloveMotoryDOTsk

Жыл бұрын

These engines have an RPM controler

itu venbelx ukuran brpa bos

We wanted to see sum load on it

@DieseloveMotoryDOTsk

Жыл бұрын

Please watch the whole video, it's there 😀

Dobrý deň, motory kupujete alebo si ich nechávate dovážať z inej krajiny?

@DieseloveMotoryDOTsk

Жыл бұрын

Dobry den, motory dovazame priamo od vyrobcov.

@leovicenik7666

Жыл бұрын

@@DieseloveMotoryDOTsk a máte aj motory okolo 25hp a viac? Ak áno koľko stojí ten 25hp motor? Odkiaľ ste? Dovážate aj na slovensko?

@DieseloveMotoryDOTsk

Жыл бұрын

@@leovicenik7666 Ano, my sme firma na Slovensku. Motory mame aj skladom. Mozete ma kontaktovat na cisle +421904155143

Китайський мотор і генератор, рама фабрична,що тут саморобне?

@DieseloveMotoryDOTsk

Жыл бұрын

Sorry, I only speak English and Slovak.